登录
首页 » SCM » 高速flash AT45db041B驱动程序

高速flash AT45db041B驱动程序

于 2022-03-02 发布 文件大小:11.07 kB
0 135
下载积分: 2 下载次数: 1

代码说明:

高速flash AT45db041B驱动程序。msp430f149+at45db041b,包括源件和项目文件。-high-speed flash AT45db041B driver. Msp430f149 at45db041b, including the source documents and project documents.

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 7281读写程序//读出BC728X内部寄存器的值 调用参数为寄存器地址...
    7281读写程序//读出BC728X内部寄存器的值 调用参数为寄存器地址-7,281 literacy procedures// BC728X read out the value of the internal register call parameters register address
    2023-06-01 20:45:04下载
    积分:1
  • STM32通过串行Flash更新,没有固件库,包括:广告..
    STM32 通过串口flash更新程序, 不用固件库,包括: ADC采样, 定时器延时中断, 键盘扫描, 模拟I2C驱动 问题咨询: w123456xy@sohu.com 15189792379-STM32 through the serial flash update, without firmware libraries, including: ADC sampling, delay timer interrupt, keyboard scanning, I2C driver Advisory: w123456xy@sohu.com 15189792379
    2023-04-20 09:00:03下载
    积分:1
  • LPC17开发板例程《1
    LPC17开发板例程《1-GPIO通用IO口例程》-LPC17 GPIO code
    2023-03-19 07:00:03下载
    积分:1
  • 数码管的显示操作,同时也有按键操作程序,通过单片机控制可以直接进行显示
    数码管的显示操作,同时也有按键操作程序,通过单片机控制可以直接进行显示-Digital tube display operation, but also has key operating procedures, can be directly controlled through the single-chip display
    2023-07-27 13:15:03下载
    积分:1
  • 12232液晶控制(sed1520)驱动程序
    12232液晶控制(sed1520)驱动程序-12232 LCD control (sed1520) driver
    2023-05-11 20:00:03下载
    积分:1
  • Single
    单片机直接驱动液晶显示的汇编程序,可供单片机爱好者参考。-Single-chip direct-drive LCD compilation of procedures for single-chip reference lovers.
    2022-07-13 09:16:17下载
    积分:1
  • 这是一个128×64 的液晶显示屏的驱动程序
    这是一个128×64 的液晶显示屏的驱动程序-This is a 128 × 64 LCD driver
    2022-01-30 17:48:46下载
    积分:1
  • 用PIC16F877控制电动自行车的源程序,配有大量的说明!
    用PIC16F877控制电动自行车的源程序,配有大量的说明!-PIC16F877 controlled by the source electric bicycle,配有大量note!
    2022-09-22 04:35:03下载
    积分:1
  • MC9S12DG128B interrupted preparation, steering control, motor control code
    MC9S12DG128B中断的编写、舵机的控制、电机的控制等代码-MC9S12DG128B interrupted preparation, steering control, motor control code
    2022-02-03 07:28:57下载
    积分:1
  • 急救车与交通灯)(1)南北与东西方向,每个方面由红黄绿三个灯控制(2)南北向: 红(30秒),黄(5秒),绿(25秒)   东西向: 红(35秒),黄(5秒),...
    急救车与交通灯)(1)南北与东西方向,每个方面由红黄绿三个灯控制(2)南北向: 红(30秒),黄(5秒),绿(25秒)   东西向: 红(35秒),黄(5秒),绿(25秒)   上述基本参数可以根据实际情况自行调整,灯的变化规律与实际路口规律相同,绿灯在最后5秒钟时,黄灯亮,然后红灯亮,不允许两个方面同时亮绿灯。(3)绿灯的时间显示在数码管上进行显示。(4)可以通过一个开关控制,当开关信号为0时,整个交通灯全灭提高要求:(1)设计一个紧急控制开关信号,当紧急开关信号为1时,两个方向的灯全为红灯。紧急开关撤消后,按照开关按下之前的状态继续运行(其参数要保存)。(2)设计一个夜间行车开关,当开关按下后,两个方向都只有黄灯闪烁,其它灯熄灭。(3)设计两个方向的亮时时间可调。-emergency vehicles and traffic lights) (1) North and South and east-west direction, each with three yellow-green from red lights control (2) to the north and south : red (30 seconds), yellow (5 seconds), Green (25 seconds) to things : red (35 seconds), yellow (5 seconds) Green (25 seconds) above basic parameters can be adjusted to the actual situation, the light changes with the actual law of the same intersection, the green light in the final five seconds, the yellow light is on, and then a red light, bright, not two fronts simultaneously bright green. (3) the green light at the time displayed on the digital display control. (4) can be controlled by a
    2022-01-22 01:28:42下载
    积分:1
  • 696518资源总数
  • 106242会员总数
  • 10今日下载