-
单片机外围电路emc设计(powerpoint)
单片机外围电路emc设计(powerpoint)-microcontroller peripheral circuit design Smarts (powerpoint)
- 2022-04-06 16:06:36下载
- 积分：1
-
电机控制，用51开发，可控制电机正反转，转多少度，编码器控制。
电机控制，用51开发，可控制电机正反转，转多少度，编码器控制。-motor control, with 51 development, motor control reversion, to the number of degrees, coding control.
- 2022-03-24 02:38:02下载
- 积分：1
-
12f6usb按摩器程序
12f6usb按摩器程序 -12f6usb massage program
- 2022-04-24 07:37:47下载
- 积分：1
-
IC Card operating software : AT88SCl604 chip mode of operation there are five. T...
IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作： AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位： 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位： 当CLK为低时，在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位，而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta
- 2022-05-28 08:23:00下载
- 积分：1
-
This is my painting of the stepper motor drive GM board, of course, only applied...
这是我画的步进电机通用的驱动板，当然只是应用到初学者，版胡德不是很好，希望大家多多指教。-This is my painting of the stepper motor drive GM board, of course, only applied to the beginner, not a very good version of Ehud, I hope everyone exhibitions.
- 2022-03-23 05:44:42下载
- 积分：1
-
LTPS LCD显示屏驱动程序
LTPS QVGA LCD Driver
- 2022-12-09 00:15:03下载
- 积分：1
-
传感器接口说明:从左到右依次为通道1,地,通道2 功能:在数码管上显示传感器接口通道2输入的电压 小数部分为7位,整数部分1位...
传感器接口说明:从左到右依次为通道1,地,通道2 功能:在数码管上显示传感器接口通道2输入的电压 小数部分为7位,整数部分1位-Sensor Interface Description: from left to right channel 1, and channel 2 functions: to show possession in the digital sensor interface channel 2 voltage input for the fractional part of 7, an integral part of
- 2022-11-22 20:50:04下载
- 积分：1
-
用单片机实现的单片机语言测试的C++语言
单片机C语言实现的对ROM进行测试的C语言的源代码。可供单片机开发人员参考。-SCM C language of the ROM to test the C-language source code. SCM developed for reference.
- 2023-04-27 07:00:04下载
- 积分：1
-
FIQ有FIQ_PWM、FIQ_TMA和FIQ_TMB三个中断源,当定时器A或B计满溢出时产生中断请求信号TA_TIMEOUT_INT或TA_TIMEOUT_I...
FIQ有FIQ_PWM、FIQ_TMA和FIQ_TMB三个中断源,当定时器A或B计满溢出时产生中断请求信号TA_TIMEOUT_INT或TA_TIMEOUT_INT,CPU响应后进入中断执行相应的子程序控制二极管发光。A口的低四位接LED灯，B口的低四位接LED灯.-FIQ has FIQ_PWM, FIQ_TMA and FIQ_TMB three interrupt sources, when the timer A or B when the expiration overflow interrupt request signal TA_TIMEOUT_INT or TA_TIMEOUT_INT, CPU response after interruption of the implementation of the corresponding subprogram control light-emitting diodes. A low population of four LED lights then, B I take the low four LED lights.
- 2022-02-03 11:57:06下载
- 积分：1
-
数字温度传感器DS18B20的原理与应用.pdf
数字温度传感器DS18B20的原理与应用.pdf -数字温度传感器DS18B20的原理与应用.pdf数字温度传感器DS18B20的原理与应用.pdf
- 2022-05-07 08:41:33下载
- 积分：1
