-
keil 的相关资料，包括C语言标准和i2c总想的相关资料
keil 的相关资料，包括C语言标准和i2c总想的相关资料-keil relevant information, including the C language standards and i2c want relevant information
- 2022-06-30 22:28:10下载
- 积分：1
-
the SCM and PC communications in the Windows source code
有关单片机和PC机通信的在Windows下的源代码-the SCM and PC communications in the Windows source code
- 2022-01-25 16:44:43下载
- 积分：1
-
MCU development version of the schematic diagram, in greater detail in
单片机开发版的原理图，比较详细了-MCU development version of the schematic diagram, in greater detail in
- 2023-02-13 13:50:03下载
- 积分：1
-
AVR GCC program design CD with the book containing the AVR
AVR单片机GCC程序设计随书光盘源码
内附AVR嵌入式操作系统源码-AVR GCC program design CD with the book containing the AVR-source embedded operating system source code
- 2022-04-15 08:13:44下载
- 积分：1
-
基于89S51单片机，实现正统，方波和三角波的输出
基于89S51单片机，实现正统，方波和三角波的输出-89S51-based single-chip, to achieve legitimacy, square and triangle wave output
- 2022-01-28 15:07:50下载
- 积分：1
-
单片机测温度c程序,温度传感器为DS1624
单片机测温度c程序,温度传感器为DS1624-C Single-chip temperature measurement procedures for the DS1624 temperature sensor
- 2022-02-04 23:26:51下载
- 积分：1
-
write with 51 receiving GPS data procedures used to receive interrupted tracing...
用51写的接收GPS数据的程序，采用中断查寻来接受数据。本程序只接收纬度，经度，时间，.....接收其它数据类似-write with 51 receiving GPS data procedures used to receive interrupted tracing data. This procedure will only receive latitude, longitude, time ...... receiving other similar data
- 2022-01-25 14:19:10下载
- 积分：1
-
ds1302的汇编语言编程实例，实现日历显示，包括详细的步骤说明...
ds1302的汇编语言编程实例，实现日历显示，包括详细的步骤说明-ds1302 examples of assembly language programming, the realization of the calendar display, including a detailed description of the steps
- 2022-01-26 03:31:11下载
- 积分：1
-
* Hardware architecture: PA0
* 硬件结构： PA0-5对应６个ＬＥＤ数显管的位 ，PC0-7对应各ＬＥＤ数显管的段 ，PB4-7为键盘。
* 软件描述： 上电后，时钟从00.00.00（时/分/秒）自动走时，在走时状态时 ， 按PB4（设定
* 键）超过3秒可循环选择调整时间/工作参数 ，接着按PB5以确定选择的操作 ，进入调整操作后 ，
* 按PB5选择欲调整参数，按PB6（增加键）完成调整参数操作 。按PB7，进入时控运行，PB1亮，
* 再按PB7停止时控运行，回显走时。在定时到时，PB0点亮。- * Hardware architecture: PA0-5 corresponds 6 LED numbers to reveal the tube the position, PC0-7 corresponds each LED number to reveal the tube the section, PB4-7 is a keyboard.
* Software description: After on electricity, clock from 00.00.00 (when/a minute/second) is in luck automatically, when is in luck the condition, according to PB4 (hypothesis
* The key) surpasses for 3 seconds to be possible to circulate the choice time/operational parameter, then presses PB5 by to determine the choice the operation, after enters the adjustment operation
* Wants according to the PB5 choice to adjust the parameter, (increases key) according to PB6 to complete the adjustment parameter operation.According to PB7, enters when controls the mov
- 2022-04-16 19:29:12下载
- 积分：1
-
用四位LED数码显示管显示实时时钟单片机源程序
用四位LED数码显示管显示实时时钟单片机源程序-with four LED digital display of real-time clock source SCM
- 2023-08-22 14:00:04下载
- 积分：1
