登录
首页 » SCM » SM5964在系统编程的源代码,通过COMM串行口进行程序下载,方便嵌入式系统开发...

SM5964在系统编程的源代码,通过COMM串行口进行程序下载,方便嵌入式系统开发...

于 2022-03-10 发布 文件大小:220.91 kB
0 159
下载积分: 2 下载次数: 1

代码说明:

SM5964在系统编程的源代码,通过COMM串行口进行程序下载,方便嵌入式系统开发-programming specification of the system"s source code through COMM serial port for downloading procedures, facilitate embedded system development

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 视觉暂留,编程从一个I/O口输出一扫频信号,驱动一支LED灯闪动,频率范围为10HZ~99HZ,扫描时间为30秒,在LED闪动期间观察,一旦发现无法识别LED灯...
    视觉暂留,编程从一个I/O口输出一扫频信号,驱动一支LED灯闪动,频率范围为10HZ~99HZ,扫描时间为30秒,在LED闪动期间观察,一旦发现无法识别LED灯闪动时,按下按键K1,立即停止输出,并将此时的信号频率显示在数码管上,该信号的周期为测试者的视觉暂留时间。-Persistence of vision, programming from an I/O port outputs a sweep signal to drive an LED light flashing, the frequency range of 10HZ ~ 99HZ, scan time of 30 seconds, the LED flashing during the observation, once found it impossible to identify the LED lights flashing, press the key K1, immediate cessation of the output, and at this time the signal frequency displayed on the digital control on the test cycle of the signal" s persistence of vision time.
    2022-08-24 14:54:10下载
    积分:1
  • F020 实现ADC 采样 串口输出到上位机
    F020 实现ADC 采样 串口输出到上位机-F020 realize sampling ADC serial output to PC
    2022-03-04 01:37:24下载
    积分:1
  • 用单片机控制GPS模块C51源代码。。希望对大家了解单片机控制GPS有帮助。...
    用单片机控制GPS模块C51源代码。。希望对大家了解单片机控制GPS有帮助。-Single-chip GPS module used to control the source code C51. . Wish to understand the U.S. has helped GPS Single-chip control.
    2022-03-23 20:49:03下载
    积分:1
  • TI的CAN接口芯片sn65hvd251的说明。
    TI的CAN接口芯片sn65hvd251的说明。-TI s CAN interface chip sn65hvd251 instructions.
    2022-04-02 08:25:15下载
    积分:1
  • 汉字双排LCD液晶的驱动程序 KeilC
    汉字双排LCD液晶的驱动程序 KeilC-Chinese dual LCD driver KeilC
    2022-10-02 23:10:03下载
    积分:1
  • 这是微软的一个USB同步传输例程,虽然它是基于Intel USB开发板的,但是也很值得我们好好的研究。...
    这是微软的一个USB同步传输例程,虽然它是基于Intel USB开发板的,但是也很值得我们好好的研究。-This is a USB synchronization routines, although it is based on the Intel USB development board, but also worthy of our good look.
    2023-08-02 06:40:03下载
    积分:1
  • This experimental report on the multi
    这篇实验报告是关于单片机多路数据采集的,本实验由2大部分组成:1、为用EPOROM构成的心电信号发生器;2、为多路信号的微机采集与显示;第一部分实验主要研究可编程序存储器EPROM的非计算机应用。把存储在EPROM中的数字心电信号读出并通过D/A转换为模拟信号显示在示波器屏幕上。 第二部分实验的目的是研究一个数据采集系统,该系统利用ECD-51型单片机为中心,由D/A芯片等将各种低频信号以及由EPROM产生的模拟人体心电信号变换成离散的数字信号存入微机内存,以待进行数据处理和分析,然后再通过D/A转换将其还原成模拟信号显示在示波器的屏幕上。 -This experimental report on the multi-SCM data acquisition, the experiment by the two major components : 1. EPOROM pose for the use of the ECG signal generator; 2, multi-path signals in the computer acquisition and display; the first major study of experimental programmable EPROM memory in non-computer applications. Stored in the EPROM of ECG read out by D/A conversion of analog signals displayed on the oscilloscope screen on. Part II The purpose of this experiment is to study a data acquisition system, which uses ECD-51 microprocessor as the center, from the D/A chips, and other various low-frequency signal from EPROM and the simulation of human ECG transform into several discrete signal words into computer mem
    2022-02-02 04:12:54下载
    积分:1
  • DAC0832 displayed waveform
    DAC0832显示波形-DAC0832 displayed waveform
    2022-03-29 15:40:36下载
    积分:1
  • device driver code I2C part
    Microchip PIC18F 设备驱动代码 I2C部分-device driver code I2C part
    2022-10-07 17:20:03下载
    积分:1
  • HD7279驱动程序,2×4键盘,指示8个灯亮
    HD7279驱动程序,2×4键盘,指示8个灯亮-HD7279 driver, 2 × 4 keyboard, instructions 8 lights
    2023-06-27 19:15:03下载
    积分:1
  • 696518资源总数
  • 105877会员总数
  • 14今日下载