-
LSB，VC实现 LSB，VC实现
LSB，VC实现 LSB，VC实现-LSB, VC realize LSB, VC realize
- 2022-01-30 21:19:57下载
- 积分：1
-
含交通灯，电子琴，时钟，键盘扫描，串口通信等汇编程序实例，非常适合初学者。...
含交通灯，电子琴，时钟，键盘扫描，串口通信等汇编程序实例，非常适合初学者。-with traffic lights, flower clock, keyboard, serial communications, and other examples of the compilation process and are very suitable for beginners.
- 2022-11-02 16:50:03下载
- 积分：1
-
声卡采集系统的设计，很好的事例，希望对大家有很大的帮助，我们也互相交流...
声卡采集系统的设计，很好的事例，希望对大家有很大的帮助，我们也互相交流-sound sample design
- 2022-01-22 14:52:04下载
- 积分：1
-
汽车电子转速表电路，包括原理图和印制板图，使汽车电子的典型电路，值得学习...
汽车电子转速表电路，包括原理图和印制板图，使汽车电子的典型电路，值得学习-automotive electronic tachometer circuit, including schematic and PCB plans, the typical automobile electronic circuits, it is worth learning
- 2022-01-24 16:14:58下载
- 积分：1
-
基于51单片机动态显示数码管,及中断说明等
基于51单片机动态显示数码管,及中断说明等-51 MCU-based dynamic display of digital control
- 2022-03-11 01:52:29下载
- 积分：1
-
用C51开发的单片机多机通讯程序，其中包括双口RAM的读写程序。
这个程序调试通过，应用在我开发的系统中，效果很好。...
用C51开发的单片机多机通讯程序，其中包括双口RAM的读写程序。
这个程序调试通过，应用在我开发的系统中，效果很好。-C51 Microcontroller with the development of multi-machine communication procedures, including dual-port RAM reading and writing process. Debugging through this process, the application in my development system, good results.
- 2022-11-07 15:45:02下载
- 积分：1
-
SmartGen generated with a size of 256* 8 Synchronous FIFO, and sending data thro...
用SmartGen生成一个256*8的大小同步FIFO，并通过串口发送数据初始化FIFO。然后，再通过串口返回到上位机的串口调试程序显示，确认数据是否正确。-SmartGen generated with a size of 256* 8 Synchronous FIFO, and sending data through the serial port to initialize FIFO. And then back through the serial port to the PC serial port debugger display to confirm the data is correct.
- 2022-03-03 12:50:01下载
- 积分：1
-
NEC 78K0LCD显示与音乐蜂鸣驱动程序
NEC 78K0LCD显示与音乐蜂鸣驱动程序-NEC 78K0LCD display driver and music buzz
- 2022-04-29 16:53:57下载
- 积分：1
-
自制AVR串口仿真器资料，用M16试制成功，仿真软件AVRSTUDIO，串口线要按图短接，速度较慢但能用成本低...
自制AVR串口仿真器资料，用M16试制成功，仿真软件AVRSTUDIO，串口线要按图短接，速度较慢但能用成本低-Home AVR emulator serial data, with the success of M16 trial, simulation software AVRSTUDIO, serial line shorted according to plan, but can be slow and low cost
- 2022-08-07 15:42:36下载
- 积分：1
-
MCS
MCS-51单片机有5个中断源，其中两个是由-INT0、-INT1引脚输入的外部中断源；另外三个是内部中断源即由T0、T1的溢出引起中断和串行口发送完一个字节或接收到一个字节数据引起中断。触发外部中断有两种方式，即下降沿引起中断或低电平引起中断。当编程TCON中的ITi（i=0、1）为1时，则引起触发的方式为边沿触发方式，反之(ITi=0)为低电平触发方式。每个中断源的中断请求能否得到响应要受两级“开关”的控制，即一个总“开关”-MCS-51 single-chip has five interrupt sources, two of which are by-INT0,-INT1 pin input external interrupt source the other three internal interrupt sources from the T0, T1 overflow caused by the disruption and serial port sending or receiving end of a byte to a byte of data caused by interruption. Triggered external interrupt has two modes, namely, falling edge or low-level disruption caused disruption caused. When programming TCON in ITi (i = 0,1) for the 1:00 has been the subject of a way to trigger the way to the edge of the trigger, on the contrary (ITi = 0) for low-level trigger mode. Each interrupt source interrupt request can be subject to levels in response to
- 2023-07-06 00:00:03下载
- 积分：1
