登录
首页 » SCM »

于 2022-03-17 发布 文件大小:4.40 kB
0 6697
下载积分: 2 下载次数: 1

代码说明:

具有多重功能的C程序,用于倒计时使用。 人行,车行自动识别.-Multi-function C procedures for the use of the countdown. People

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 音乐兰花草播放演示,汇编编写,用的是扬声器,不是蜂鸣器!...
    音乐兰花草播放演示,汇编编写,用的是扬声器,不是蜂鸣器!-Music orchids player demo, compilation of writing, using a speaker, not the buzzer!
    2022-09-05 13:00:03下载
    积分:1
  • AT89C2051 vacuum source for timing controller
    AT89C2051蒸饭器定时控制器源程序-AT89C2051 vacuum source for timing controller
    2022-10-29 04:15:03下载
    积分:1
  • two computer guide books Huazhong University of Science and Technology in Wuhan...
    2位微机实验指导书 华中科技大学计算机学院 武汉市豪申光电新技术有限公司 第一章 基本接口实验 2 第一节 并行接口实验(8255芯片实验) 2 实验一 步进电机控制接口实验 2 第二节 定时/计数实验(8253芯片实验) 9 实验二 音乐发生器接口实验 9 第三节 串行通信接口实验(8251芯片实验) 21 实验三 RS-232标准全双工查询方式异步串行通信实验 21 第四节 A/D D/A转换器接口实验 32 实验四 查询方式A/D转换器接口实验(ADC0809) 32 实验五 D/A函数波形发生器接口实验(DAC0832) 40 第二篇 微机原理实验 44 第一章 16位汇编语言编程实验 44 实验一 系统认识实验 44 实验二 数据码制转换程序设计实验 49 实验三 求和程序设计实验 59 实验四 分支程序设计实验 68 实验五 循环程序设计实验 77 实验六 排序程序设计实验 86 实验七 子程序设计实验 95-two computer guide books Huazhong University of Science and Technology in Wuhan City Computer College ho optoelectronic applications of new technologies first Limited Chapter two basic interface experimental section I Parallel Interface (8,255 microarray experiment) into two experimental step motor control interface is regular inspection section 2/Counting Experiment (8253 experiment) 9 2 Experimental Music Generator Interface 9 Section III Series Communication Interface Experiment (82
    2023-04-02 08:05:05下载
    积分:1
  • 开源的嵌入式WEB服务器,运行于RAM处理器,占用的系统资源极少...
    开源的嵌入式WEB服务器,运行于RAM处理器,占用的系统资源极少-revenue embedded Web server running on the processor RAM and occupies very little system resources
    2022-01-25 19:06:36下载
    积分:1
  • 零耗时低频宽脉冲软PWM信号控制Keil C51演示程序,转摘!
    零耗时低频宽脉冲软PWM信号控制Keil C51演示程序,转摘!-zero time-consuming low-bandwidth pulses Soft PWM control signal Keil C51 demo program, journals!
    2022-12-01 20:15:03下载
    积分:1
  • 基于1602LCD的秒表,MCU STC89C51RC。
    基于1602LCD的秒表,MCU STC89C51RC。-The stopwatch-based 1602LCD
    2022-03-24 17:19:59下载
    积分:1
  • 用过采样和求均值技术提高模数转换器的分辨率.pdf
    用过采样和求均值技术提高模数转换器的分辨率.pdf-----针对目前单片机内嵌的模/数转换器的分辨率太低,而外接高分辨率成本又太高的情况,提出了用“过采样和求均值”的技术来使在有用的测量频带内的信噪比得到改善,从而提高测量的分辨. 率。并利用 60 - 7 0 /对其结论进行仿真,且在单片机上予以实现,结果表明测量分辨率明显提高。-Sampling and averaging techniques used to improve the resolution of ADC. Pdf----- targeted at the embedded microcontroller A/D converter resolution is too low, while the external high-resolution costs are too high situation, put forward with " Oversampling and Averaging" technology to make useful measurements in the frequency band signal to noise ratio to be improved, thereby enhancing the measurement resolution. rate. And a 60- 7 0/simulation of its conclusions, and in the SCM to be achieved, results show that the measurement resolution has improved significantly.
    2022-12-03 01:20:03下载
    积分:1
  • RS232通信程序,初学者的入门程序,很有用的
    RS232通信程序,初学者的入门程序,很有用的-RS232 communication procedures, entry procedures for beginners, very useful
    2022-02-05 01:23:49下载
    积分:1
  • 基于PIC16单片机的门铃控制程序,已经通过编译
    基于PIC16单片机的门铃控制程序,已经通过编译-Based on the PIC16 MCU doorbell control procedures have been adopted by the compiler
    2022-05-27 20:48:07下载
    积分:1
  • 1.熟悉硬件仿真工具KD30的使用。 2.修改样本程序 SAMP1a,使无论在计数或停止计数时,按 SW3 均对计数值清零,并停止计数。 3.编制一个秒表程序,...
    1.熟悉硬件仿真工具KD30的使用。 2.修改样本程序 SAMP1a,使无论在计数或停止计数时,按 SW3 均对计数值清零,并停止计数。 3.编制一个秒表程序, 测试精度为0.1秒,按 SW1键启动计数,再按一次 SW1键停止计数。任何时候按 SW3 键停止计数,并对计数值清零。 4.按 SW1键后, 以 0.1 秒为单位开始计数,再按一次 SW1 键停止计数。若按 SW1 键时间超过2秒,则计数值清零,回到初始状态。-1. Familiar with the hardware simulation tool KD30 use. 2. Revised procedures SAMP1a samples, regardless of the count or counts at the end, according to SW3 numerical terms were right, reset, and stop counting. 3. Preparation of a stopwatch procedures, testing accuracy of 0.1 seconds, according to bond SW1 start counting, according to a key SW1 stopped counting. By SW3 any time to stop counting bond and reset the count. 4. By SW1 bond, after 0.1 seconds for start counting, according to a key SW1 stopped counting. If SW1 keys by the time more than two seconds, then reset the count and return to the initial state.
    2023-08-01 05:40:03下载
    积分:1
  • 696518资源总数
  • 106161会员总数
  • 5今日下载