登录
首页 » 汇编语言 » 电子密码锁程序,用ASM编写,键盘6位密码,有开锁报警子程序

电子密码锁程序,用ASM编写,键盘6位密码,有开锁报警子程序

于 2022-03-21 发布 文件大小:4.62 kB
0 174
下载积分: 2 下载次数: 1

代码说明:

电子密码锁程序,用ASM编写,键盘6位密码,有开锁报警子程序-Electronic code lock procedure, prepared by ASM, keyboard 6 password, have become disengaged alarm subroutine

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • Realize the storage and classification of the input points, and ultimately the f...
    实现对分数的输入存储及分类,并最终以计数的形式在dos中显示!-Realize the storage and classification of the input points, and ultimately the form of innumerable dos to display!
    2022-03-20 03:55:20下载
    积分:1
  • 4*4键盘扫描,依据键值,8个LED显示相应键值
    4*4键盘扫描,依据键值,8个LED显示相应键值-4* 4 keyboard scanning, based on keys, 8 LED display the corresponding key
    2022-05-22 20:01:40下载
    积分:1
  • TS1602 LCD 显示的例子,包括,LCD的初始化,显示一行文字,清屏
    TS1602 LCD 显示的例子,包括,LCD的初始化,显示一行文字,清屏-TS1602 LCD display examples, including, LCD initialization, showing a line of text, the Qing Ping
    2022-03-02 06:26:16下载
    积分:1
  • 定时器程序采用89c2051
    定时器程序采用89c2051 -timer procedures used 89c2051
    2022-02-02 10:27:08下载
    积分:1
  • 基带传输常用码的码解码MATLAB方法
    基带传输常用码的编码解码MATLAB方法 -baseband transmission
    2022-05-06 11:49:04下载
    积分:1
  • 代码实现一个圆形的先入先出(FIFO)缓冲器…
    To write assembly code to implement a circular First In First Out (FIFO) buffer in the data memory of PIC18F452 microcontroller, using the microcontroller’s direct addressing mode and indirect addressing mode. To expand on the FIFO assignment and implement the FIFO solution on the QWIKFLASH PIC target board and display the FIFOSTATUS as LED indicators. Recall: Flags within a file register called FIFOSTATUS: • Bit 0: FIFO_full • Bit 1: FIFO_empty • Bit 2: attempt_2_read when FIFO_empty • Bit 3: attempt_2_write when FIFO_full
    2023-05-10 17:35:03下载
    积分:1
  • 设计一种自动洗衣机的程序控制器,在启动后先进水,等到达高水位后,启动洗衣马达转动4min,如在洗衣过程中发现水位低于高水位,则停止洗衣马达转动并报警,并在水位到...
    设计一种自动洗衣机的程序控制器,在启动后先进水,等到达高水位后,启动洗衣马达转动4min,如在洗衣过程中发现水位低于高水位,则停止洗衣马达转动并报警,并在水位到达高水位后再次启动马达。洗衣结束后则启动排水开关,待水位到达低水位后,则启动脱水马达,转动2min。如此重复三次,要求在每一动作之间有2s的间隔。 高水位,低水位为水位传感器,用两个开关模拟,当水位高于高水位或低于低水位时,两个开关的状态分别为0 。启动开关用一个开关表示。进水、排水、洗衣马达、脱水马达及报警分别用一个发光二极管表示。本实验只需用可编程并行接口电路的A口。其硬件接口如下图所示。也可采用可编程逻辑器件进行设计。 -Design of an automatic washing process controller, after commencement of advanced water, and so on to reach the high water mark, start laundry motor rotation 4min, such as in laundry water level lower than that found during the high water mark, then the motor stops rotating laundry and alarm, and the the water level reaches the high water mark again to start the motor. Laundry is started after the end of the drainage switch, when the water level reaches the low water level, then start the dehydration motors, rotating 2min. Repeat three times, each action requires the interval between the 2s. High water, low water level as water level sensors, with two analog switches, when the water
    2023-04-30 10:55:03下载
    积分:1
  • 机器人遍历障碍地图
    机器人遍历障碍地图-robot traverse obstacles map
    2022-06-15 18:42:33下载
    积分:1
  • 多位的加减运算,允许有负数.
    多位的加减运算,允许有负数.-number of addition and subtraction operations and allow a negative.
    2023-09-08 03:40:02下载
    积分:1
  • Enter the string from the keyboard using bios string showing the results of
    从键盘中输入一串字符串用bios显示出结果-Enter the string from the keyboard using bios string showing the results of
    2022-02-05 16:51:20下载
    积分:1
  • 696518资源总数
  • 105540会员总数
  • 37今日下载