-
pic 单片机红外接收分析仪的资料，PC软件部分，pdf文件格式，请参考使用...
pic 单片机红外接收分析仪的资料，PC软件部分，pdf文件格式，请参考使用-pic microcontroller infrared analyzer to receive the information, PC software, pdf format, please refer to the use of
- 2022-01-26 02:54:20下载
- 积分：1
-
该文件是在LCM12864驱动代码的LPC2131
此文件是LCM12864在LPC2131上的驱动代码-This file is in LCM12864 driver code on the LPC2131
- 2022-02-02 15:20:01下载
- 积分：1
-
51单片机+FI1256高频头=电视接收机源代码
51单片机+FI1256高频头=电视接收机源代码-51 SCM+ FI1256 tuner = television receiver source code
- 2022-05-19 13:23:18下载
- 积分：1
-
通过红外对管实现无线通信，下位机可以通过数据采集转换，通过红外向上位机发送并显示...
通过红外对管实现无线通信，下位机可以通过数据采集转换，通过红外向上位机发送并显示-Through infrared to control the realization of wireless communications, next-bit machine can be converted through the data acquisition through infrared upward-bit machine to send and display
- 2023-01-19 07:30:03下载
- 积分：1
-
=== =时钟20:6=== === ==
应先初始化状态寄存器
tx1714 EQU 7FFH
PA EQU 05H
PB EQU 0...
=== =时钟20:6=== === ==
应先初始化状态寄存器
tx1714 EQU 7FFH
PA EQU 05H
PB EQU 06H
PC EQU 07H
PD EQU 20H
IAR EQU 00H 间接寻址寄存器
TMR0 EQU 01H 定时器
STATUS EQU 03H 状态寄存器
BSR EQU 04H bank选择寄存器
PORTA EQU 05H I/0端口寄存器
PORTB EQU 06H I/0端口寄存器
PORTC EQU 07H I/0端口寄存器
PORTD EQU 20H I/0端口寄存器
PULL EQU 21H PULL-High上拉寄存器
WAKEUP EQU 22H 唤醒控制寄存器－－被用来设定watchdog允许和禁止
IRQM EQU 23H 中断屏蔽寄存器
IRQF EQU 24H 中断标志寄存器
WDTSEL EQU 25H
-=== === = clock 20 : 6 === === === == should first register initialization state tx1714 EQU 7FFH EQU PA PB EQU 05H 06H 07H PC EQU PD EQU 20H IAR E QU 00H indirectly addressable registers TMR0 EQU 01H timer STATUS EQU Mr send state BSR EQU-deposit bank in the 04H choice Register PORTA EQU 05H I/O ports Register P ORTB EQU 06H I/O ports Register PORTC EQU 07H I/O ports Register POR TD EQU 20H I/O ports Register PULL EQU 21H PULL-High pull Register WAKEUP EQU 22H awaken control registers-- were used to set watchdog allowed and prohi
- 2022-03-18 22:55:02下载
- 积分：1
-
对于基本的显示屏1602,怎样用最简单的方式操作呢,本程序就给了一个实例....
对于基本的显示屏1602,怎样用最简单的方式操作呢,本程序就给了一个实例.-1602 for the basic screen, how to use the most simple way to operate it, the program gives an example.
- 2022-01-26 02:07:37下载
- 积分：1
-
keilc+ proteus light parallel port design of experiments requirements: master th...
keilc + proteus
并行口设计指示灯实验
要求：掌握80C51单片机输入输出接口使用方法
学会开关量输入输出控制的接口技术及编程方法
实验题目：8个发光二极管D1~D8分别接在单片机P1.0-P1.7端口上，一个开关接在P3.0上。要求输出端口输出 “0”时，发光二极管亮。开关闭合时，开始按P1.0-P1.1-...-P1.7的顺序依次点亮LED，再按 P1.7-P1.6 -...-P1.0的顺序点亮LED，重复循环。开关断开时，立刻停止点亮指示灯。-keilc+ proteus light parallel port design of experiments requirements: master the 80C51 microcontroller input and output interfaces Society of switch to use the amount of input and output control interface technology and programming methods Experimental subjects: eight light-emitting diodes D1 ~ D8, respectively connected to the MCU P1.0-P1 .7 port on a switch connected to the P3.0 on. Requested output port output " 0" , the light-emitting diode light. Is closed, to embark on the P1.0-P1.1-...- P1.7 in the order light LED, and then P1.7-P1.6-...- P1.0 order light LED Repeat cycle. Switch off when the stop light indicator.
- 2022-11-16 18:10:03下载
- 积分：1
-
完整的ＴＣＳ控制系统原程序．包含系统检测，数据采集（Ａ－Ｄ）与处理，通信和回路控制与检测．产品已上市．...
完整的ＴＣＳ控制系统原程序．包含系统检测，数据采集（Ａ－Ｄ）与处理，通信和回路控制与检测．产品已上市．-integrity of the original control system procedures. Includes system testing, data acquisition (A-D) and processing, communication and loop control and detection. Products are listed.
- 2022-06-28 09:59:38下载
- 积分：1
-
W3100是WIZnet公司专门为以太网互联和嵌入式设备推出的硬件TCP／IP协议栈芯片，其硬件TCP／IP协议栈包含了TCP、UDP、IP、ARP和ICMP协...
W3100是WIZnet公司专门为以太网互联和嵌入式设备推出的硬件TCP／IP协议栈芯片，其硬件TCP／IP协议栈包含了TCP、UDP、IP、ARP和ICMP协议，这是-WIZnet W3100 is designed for the Internet and Embedded Ethernet equipment introduced hardware TCP/IP protocol stack chips, and hardware TCP/IP protocol stack includes TCP, UDP, IP, ICMP and ARP agreement, which is
- 2022-02-04 00:02:39下载
- 积分：1
-
CF8051F040开发板的SRAM_rw_test 程序
CF8051F040开发板的SRAM_rw_test 程序-CF8051F040 development board
- 2023-01-27 05:40:03下载
- 积分：1
