-
Easy web use Cs8900a
简易网络使用Cs8900a
- 2022-04-24 08:00:04下载
- 积分：1
-
优龙ARM9开发板ST2410的例程，ADS编译环境
优龙ARM9开发板ST2410的例程，ADS编译环境-Liuzhou excellent ARM9 development board ST2410 routine, ADS compiler environment
- 2022-08-02 17:59:23下载
- 积分：1
-
j基于STM32 串口显示温度源程序
基于STM32串口显示温度的源程序，系统读取到温度传感器DS18B20的温度值后，通过串口，发送到电脑的串口调试助手哪里显示出来~~~
- 2022-05-31 18:32:37下载
- 积分：1
-
相当不错的源码，希望对大家有用，里面有CCD摄像头的驱动及应用程序，大家可以参考其设计模式...
相当不错的源码，希望对大家有用，里面有CCD摄像头的驱动及应用程序，大家可以参考其设计模式-a ARM7 CCD pro.
- 2022-11-29 10:50:03下载
- 积分：1
-
汽车行业专用通讯，或是工业控制上应用，可靠性是can bus 的最大的优点。但CNA BUS 的通讯协议比较烦琐，本人也是刚刚才调通这个程序。...
汽车行业专用通讯，或是工业控制上应用，可靠性是can bus 的最大的优点。但CNA BUS 的通讯协议比较烦琐，本人也是刚刚才调通这个程序。-Automotive industry-specific communications, or industrial control applications, can bus reliability is the biggest advantage. However, CNA BUS protocol relatively cumbersome, and I was just transferred pass this procedure.
- 2022-01-26 01:53:10下载
- 积分：1
-
（U盘MP3）FAT文件系统的源代码，U盘，MP3文件系统下，福…
(U盘MP3)FAT文件系统源码,u盘，mp3下的文件系统，完全兼容fat16，fat32，加上自己的硬盘驱动接口后应该可以使用-(U disk MP3) FAT file system source code, u disks, mp3 under the file system, fully compatible fat16, fat32, coupled with its own hard disk drive interface can be used after
- 2022-03-13 03:06:24下载
- 积分：1
-
25L256B是先进技术制造铁电256KB号使用。
FM25L256B是采用先进的铁电技术制造的256Kb非易失性存储器。铁电随机存储器（FRAM）具有非易失性，并且可以象RAM一样快速读写。数据在掉电后可以保存10年，同时消除由EEPROM和其他非易失性存储器导致的复杂性，开销和系统级别可靠性问题。
-FM25L256B is the use of advanced technology manufacturing ferroelectric 256Kb nonvolatile memory. Ferroelectric random access memory (FRAM) with a non-volatile, and can read and write as quickly as RAM. Data can be saved in the power-down after 10 years, while eliminating by EEPROM and other nonvolatile memory led to the complexity, overhead and system level reliability problems.
- 2022-04-25 08:42:15下载
- 积分：1
-
2410 nand boot load! (4K DRAM) 0 addresses begin, as VIVI not copy itself to hig...
2410 nand boot load!（4K DRAM)
0地址开始运行，没有象VIVI拷贝自身到
高端内存运行，可以用它加载UBOOT。
也可以改写它用来引导自己的系统-2410 nand boot load! (4K DRAM) 0 addresses begin, as VIVI not copy itself to high-end memory operation, can be used UBOOT load. It can also rewrite used to guide their systems
- 2022-07-26 14:06:45下载
- 积分：1
-
2812使用spi读写fm25cl64或者at25640的程序，已经测试通过。注意在在eeprom的datasheet中都写只支持spi的0或者3模式，但我用0...
2812使用spi读写fm25cl64或者at25640的程序，已经测试通过。注意在在eeprom的datasheet中都写只支持spi的0或者3模式，但我用0模式一直调不通，改用spi模式才可以，程序中就是使用spi的1模式。-2812 to read and write using spi or at25640 procedures FM25CL64 have the test. Attention to the datasheet in the EEPROM are write only support spi mode 0 or 3, but I used the 0 model has been adjusted barrier before they can switch to spi mode, process is the use of one mode of spi.
- 2022-01-25 21:08:07下载
- 积分：1
-
his project was built and tested with WinAVR
his project was built and tested with WinAVR-20060125.
Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!!
To build the code, just install WinAVR and run "make" from the console in echomaster and
echoslave subdirs.
"make program" will program the device if you have a AVRISP attached.
Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock
from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST!
Otherwise you wont get any clock signal to the AVR and then you can t program it or reset
the fuses!
The MC1319x has default clock output of 32kHz so you will have to set your programmer to
a very low frequency (
- 2023-02-22 21:55:03下载
- 积分：1
