-
本程序为lcm128x64驱动器KS0108控制器，具有中国特色的…
本程序为LCM128X64的驱动程序，控制器为KS0108，即有汉字驱动程序，又有图形驱动程序。-This procedure for LCM128X64 driver, controller KS0108, which has Chinese characters drivers, and graphics drivers.
- 2022-05-30 16:32:59下载
- 积分：1
-
ATmega128单片机的在线升级程序，由于协议编程，通过..
atmega128在线升级程序，自编程通过xmodem协议
-atmega128 online promotion procedures, since the programming agreement through XModem
- 2022-03-25 21:12:03下载
- 积分：1
-
C8051F350 中文数据手册 初学者开发的好工具
C8051F350 中文数据手册 初学者开发的好工具-C8051F350 Data Sheet Chinese developed a good tool for beginners
- 2022-02-06 02:58:51下载
- 积分：1
-
频率计，精度高，可以自动换档，一般单片机可以达到0…500k
频率计，精度高，可以自动换档，一般单片机可以达到0…500k-Frequency, high precision, can automatic transmission, the general single-chip microcomputer can be 0 ... 500k
- 2022-07-19 08:50:12下载
- 积分：1
-
单片机P1口与4个按键连接，用于信号幅度和频率调节操作键。单片机P0、P2.7、P3.6(
单片机P1口与4个按键连接，用于信号幅度和频率调节操作键。单片机P0、P2.7、P3.6(-WR)与DA0832、2个741(运放)连接构成波形信号输出电路。
编程使波形信号输出电路输出正弦波信号，并且可通过操作键调节信号的幅度和频率。幅度和频率调节级别从0~10，共11个等级。
-Singlechip P1 I connect with the four buttons for the signal amplitude and frequency adjustment operation keys. Singlechip P0, P2.7, P3.6 (-WR) and DA0832, 2 months 741 (operational amplifier) to connect constitute waveform signal output circuit. Programming so that waveform signal output circuit output sine wave signal, and can be operated keys adjust the signal amplitude and frequency. Amplitude and frequency adjustment level from 0 ~ 10, a total of 11 grades.
- 2022-04-14 22:06:25下载
- 积分：1
-
192* 64_stn_ks108_ LCD procedures .......................
192*64_stn_ks108_液晶程序-192* 64_stn_ks108_ LCD procedures .......................
- 2022-05-07 03:41:33下载
- 积分：1
-
MSP430 MCU to download the official line schematic drawings
MSP430 单片机的下载线原理图
官方图纸-MSP430 MCU to download the official line schematic drawings
- 2022-06-03 09:57:39下载
- 积分：1
-
UARTDemo使用UART中断方式进行通讯的范例
UARTDemo使用UART中断方式进行通讯的范例-UARTDemo use UART interrupt communication paradigm
- 2022-09-28 15:55:03下载
- 积分：1
-
读韦根26程序,将韦根26代码读取到单片机进行显示和处理
读韦根26程序,将韦根26代码读取到单片机进行显示和处理-read wiegand program
- 2023-06-23 18:35:03下载
- 积分：1
-
spi 翻译资料 7.2 SPI总线
SD卡信道由指令和数据位（起始位和结束位）组成，SPI信道由字节定向。
每一个指令或数据块由8位的字节和CS标志构...
spi 翻译资料 7.2 SPI总线
SD卡信道由指令和数据位（起始位和结束位）组成，SPI信道由字节定向。
每一个指令或数据块由8位的字节和CS标志构成。类似SD卡协议, SPI通讯由
指令、响应和数据组成。全部的主机与SD卡之间的通信由主机控制。主机执行
每一跟CS标志为低的总线-spi Translation 7.2 SPI bus data channel from the SD card command and data bit (start bit and end bit) component, SPI channel directed by byte. Every command or data block from 8-bit bytes and CS constitute signs. SD card similar to the agreement, SPI communications from command, response and data components. All of the host and the communications between the SD card by the host control. Each host implementation with CS low marks for bus
- 2023-04-25 13:15:05下载
- 积分：1
