登录
首页 » SCM » RC531, mifare card receiver chip, to achieve non

RC531, mifare card receiver chip, to achieve non

于 2022-04-25 发布 文件大小:57.55 kB
0 155
下载积分: 2 下载次数: 1

代码说明:

RC531,mifare卡的接收芯片,实现非接触卡的应用-RC531, mifare card receiver chip, to achieve non-contact card application

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 使用显示接收到的数据,使用液晶显示器使用字符*…
    使用LED显示接收到的数据,使用LCD显示发送的字符 * 程序使用波特率为9600,程序运行时需要在pc机上使用一个串口 * 接收发送程序,发送字符应为asc码,接收的字符为十六进制-The use of LED display received data sent using the LCD display uses characters* for 9600 baud rate, the program needs to run-time machine pc using a serial port* send procedure to receive, send characters should asc yards receiving for the characters Hexadecimal
    2022-07-17 16:29:16下载
    积分:1
  • 24C02的读写操作,用汇编语言完成,在开发板上运行正常
    24C02的读写操作,用汇编语言完成,在开发板上运行正常-24C02
    2022-06-17 12:26:49下载
    积分:1
  • 基于STC89C52单片机的3音阶电子琴 带自动播放
    基于STC89C52单片机的3音阶电子琴 带自动播放-3 Based on scale SCM STC89C52 Electronic organ with automatic play
    2022-01-27 10:34:11下载
    积分:1
  • Proteus under pieces of a case (51 microcontroller, c51 works documents and comp...
    Proteus下件一个案例(51单片机,c51工程文件及完整源代码)
    2022-03-20 13:11:50下载
    积分:1
  • IC Card operating software : AT88SCl604 chip mode of operation there are five. T...
    IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作: AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位: 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位: 当CLK为低时,在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位,而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta
    2022-05-28 08:23:00下载
    积分:1
  • LT_1B msp430开发板例子程序-UART_U1152
    LT_1B msp430开发板例子程序-UART_U1152-LT_1B msp430开发板例子程序-UART_U115200
    2022-01-26 01:18:38下载
    积分:1
  • 环境是IAR,本实例应用于大棚或是其他需要温度控制的场合,可以供大家参考一下。...
    环境是IAR,本实例应用于大棚或是其他需要温度控制的场合,可以供大家参考一下。-Environment is the IAR, the examples used in greenhouses or other occasions the need for temperature control, you can refer to for everyone.
    2022-08-25 07:58:51下载
    积分:1
  • PIC12C5XX单片机应用举例,汇编语言编写
    PIC12C5XX单片机应用举例,汇编语言编写-PIC12C5XX SCM application, for example, the compilation of language
    2022-04-29 22:41:09下载
    积分:1
  • 320x240图形液晶驱动液晶1602字符液晶44780总线驱动程序的演示程序…
    320x240图形液晶驱动 1602液晶显示 44780字符液晶屏驱动演示程序总线方式 M12864汉字液晶显示驱动程序-320x240 graphic LCD driver LCD 1602 LCD 44780 characters Bus Driver demo program M12864 characters liquid crystal display driver
    2022-01-26 02:23:45下载
    积分:1
  • single
    单键遥控器的设计 有程序加说明 并且功能强大-single-button remote control procedures for the design description and powerful
    2023-02-02 11:40:03下载
    积分:1
  • 696516资源总数
  • 106554会员总数
  • 12今日下载