登录
首页 » SCM » 这是我的毕业设计

这是我的毕业设计

于 2022-04-29 发布 文件大小:6.30 kB
0 137
下载积分: 2 下载次数: 1

代码说明:

这是我的毕业设计-智能排队系统的操作器源码,上载给大家做参考,希望大家赐教.-This is my graduation design-smart queuing system for the operation of the source code, available to you for reference. We hope that substantive progress.

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • C51源数据库,许多情况下,51个研究的基础
    C51源程序库,一些例,学51单片机的基础用-C51 source database, a number of cases, the basis of study with 51 single-chip microcomputer
    2022-01-20 23:25:01下载
    积分:1
  • 字母钟系统的实现代码,GPS卫星时钟对时的实现。汇编源吗
    字母钟系统的实现代码,GPS卫星时钟对时的实现。汇编源吗-alphabetical system of code, the GPS satellite clocks on the achievement. Compilation source?
    2022-04-28 18:27:03下载
    积分:1
  • 我做的按摸椅RS001的键盘部分的C51程序
    我做的按摸椅RS001的键盘部分的C51程序- I do according to trace chair R S 001 keyboards partial C 51 procedures
    2022-03-07 18:07:50下载
    积分:1
  • keilc+ proteus light parallel port design of experiments requirements: master th...
    keilc + proteus 并行口设计指示灯实验 要求:掌握80C51单片机输入输出接口使用方法 学会开关量输入输出控制的接口技术及编程方法 实验题目:8个发光二极管D1~D8分别接在单片机P1.0-P1.7端口上,一个开关接在P3.0上。要求输出端口输出 “0”时,发光二极管亮。开关闭合时,开始按P1.0-P1.1-...-P1.7的顺序依次点亮LED,再按 P1.7-P1.6 -...-P1.0的顺序点亮LED,重复循环。开关断开时,立刻停止点亮指示灯。-keilc+ proteus light parallel port design of experiments requirements: master the 80C51 microcontroller input and output interfaces Society of switch to use the amount of input and output control interface technology and programming methods Experimental subjects: eight light-emitting diodes D1 ~ D8, respectively connected to the MCU P1.0-P1 .7 port on a switch connected to the P3.0 on. Requested output port output " 0" , the light-emitting diode light. Is closed, to embark on the P1.0-P1.1-...- P1.7 in the order light LED, and then P1.7-P1.6-...- P1.0 order light LED Repeat cycle. Switch off when the stop light indicator.
    2022-11-16 18:10:03下载
    积分:1
  • 单片机P1口与4个按键连接,用于信号幅度和频率调节操作键。单片机P0、P2.7、P3.6(
    单片机P1口与4个按键连接,用于信号幅度和频率调节操作键。单片机P0、P2.7、P3.6(-WR)与DA0832、2个741(运放)连接构成波形信号输出电路。 编程使波形信号输出电路输出正弦波信号,并且可通过操作键调节信号的幅度和频率。幅度和频率调节级别从0~10,共11个等级。 -Singlechip P1 I connect with the four buttons for the signal amplitude and frequency adjustment operation keys. Singlechip P0, P2.7, P3.6 (-WR) and DA0832, 2 months 741 (operational amplifier) to connect constitute waveform signal output circuit. Programming so that waveform signal output circuit output sine wave signal, and can be operated keys adjust the signal amplitude and frequency. Amplitude and frequency adjustment level from 0 ~ 10, a total of 11 grades.
    2022-04-14 22:06:25下载
    积分:1
  • 一种实用的汉字字模生成软件单片机液晶显示(源码),..
    一个实用的单片机显示液晶用汉字字模生成软件(非源码),非常实用,可生成C51或汇编格式。-a practical LCD MCU with Chinese characters Fonts generation software (FOSS), a very practical, or can be generated C51 compilation format.
    2022-11-07 06:15:03下载
    积分:1
  • c8051f340 USB传输 固件驱动, c8051f340 USB传输 固件驱动,
    c8051f340 USB传输 固件驱动, c8051f340 USB传输 固件驱动,-transmission c8051f340 USB drive firmware, c8051f340 USB transmission firmware-driven,
    2022-08-19 18:05:20下载
    积分:1
  • AT89C51SND1C程序MP3程序MP3信息AT89C51SND1C MP3信息…
    AT89C51SND1C方案mp3资料 AT89C51SND1C方案mp3资料-AT89C51SND1C program mp3 program mp3 information AT89C51SND1C mp3 information AT89C51SND1C program information
    2022-03-17 21:20:11下载
    积分:1
  • 利用单片机仿真JTAG测试驱动程序,可做测试烧录等
    利用单片机仿真JTAG测试驱动程序,可做测试烧录等-The use of single-chip JTAG emulation test driver, do the test burn, etc.
    2023-08-08 06:10:03下载
    积分:1
  • 这是AVR系列单片机1,教材及应用,解压密码是www.pp51.com
    这是AVR系列单片机1,教材及应用,解压密码是www.pp51.com-AVR
    2022-08-16 22:36:18下载
    积分:1
  • 696518资源总数
  • 106155会员总数
  • 8今日下载