-
用8051汇编编程的定点,三字节浮点,四字节浮点的字程序库。...
用8051汇编编程的定点,三字节浮点,四字节浮点的字程序库。-8051 compilation of programming with the fixed-point, three-byte floating-point, four-byte floating-point library word.
- 2022-04-29 04:38:16下载
- 积分:1
-
单片机的设计程序,我认为很好的,希望大家喜欢
单片机的设计程序,我认为很好的,希望大家喜欢-MCU design process, I think that"s good, hope you like them! !
- 2022-07-27 12:41:08下载
- 积分:1
-
keil C51 Goat2事例
keil C51 Goat2事例-examples Goat2
- 2022-06-14 18:03:45下载
- 积分:1
-
基于51系列单片机的计算器程序.开发环境:KEIL,开发语言:c51,仿真环境Proteus...
基于51系列单片机的计算器程序.开发环境:KEIL,开发语言:c51,仿真环境Proteus-51 Series single-chip microcomputer-based calculator program. Development environment: KEIL, the development of language: c51, simulation environment Proteus
- 2022-12-03 05:25:03下载
- 积分:1
-
采用AMBE语音双工收发程序产生的附加NRF2401 P.
使用AMBE制作语音双工收发的程序,可附加NRF2401制作效果更佳-Produced using the AMBE voice duplex transceiver procedures may attach nRF2401 produced better
- 2022-03-01 22:17:51下载
- 积分:1
-
PT2313 program audio control circuit 1
PT2313程序音响控制电路1-PT2313 program audio control circuit 1
- 2023-07-17 08:35:03下载
- 积分:1
-
Introduction 80C51 MCU Keil C51 Programming: 80C51 system architecture, assembly...
介绍80C51单片机的Keil C51编程:80C51的系统结构,汇编语言,C51语言,开发实例及一些注意事项.推荐!-Introduction 80C51 MCU Keil C51 Programming: 80C51 system architecture, assembly language, C51 language, the development of examples and some attention. Recommended!
- 2022-02-12 18:57:47下载
- 积分:1
-
SPI是一个环形总线结构,由ss(cs)、sck、sdi、sdo构成,其时序其实很简单,主要是在sck的控制下,两个双向移位寄存器进行数据交换。
假设下面...
SPI是一个环形总线结构,由ss(cs)、sck、sdi、sdo构成,其时序其实很简单,主要是在sck的控制下,两个双向移位寄存器进行数据交换。
假设下面的8位寄存器装的是待发送的数据10101010,上升沿发送、下降沿接收、高位先发送。
那么第一个上升沿来的时候 数据将会是sdo=1;寄存器=0101010x。下降沿到来的时候,sdi上的电平将所存到寄存器中去,那么这时寄存器=0101010sdi,这样在8个时钟脉冲以后,两个寄存器的内容互相交换一次。这样就完成里一个spi时序。
-SPI bus is a ring structure, by ss (cs), sck, sdi, sdo composition, its timing is actually very simple, mainly under the control of the sck and two bi-directional shift register for data exchange. Assuming the following 8-bit register is loaded to send the data to be 10,101,010, rising to send, receive falling edge, high first sent. Well, the first rising edge to the time data will be sdo = 1 register = 0101010x. Falling edge comes, sdi on the level will be stored to the register, then register at this time = 0101010sdi, so 8 clock pulse later, the contents of two registers to exchange time. This will be completed in a spi timing.
- 2022-02-06 05:39:49下载
- 积分:1
-
用8051单片机控制的基于DS18B20的温度上下限控制报警的KEILC工程文件...
用8051单片机控制的基于DS18B20的温度上下限控制报警的KEILC工程文件-By 8051 the control of the temperature of upper and lower limits based on DS18B20 control alarm KEILC project file
- 2022-02-11 12:10:00下载
- 积分:1
-
GPS开发,单片机接受代码,对于使用者非常重要
GPS开发,单片机接受代码,对于使用者非常重要-GPS
- 2023-01-29 17:40:03下载
- 积分:1