登录
首页 » 嵌入式系统 » 自动升降电梯控制器设计 要求: 设计一个6层楼的电梯控制器。 该控制器可控制电梯完成6层楼的载客服而且遵循方向优先原则,并能响应提前关门延时关门,并...

自动升降电梯控制器设计 要求: 设计一个6层楼的电梯控制器。 该控制器可控制电梯完成6层楼的载客服而且遵循方向优先原则,并能响应提前关门延时关门,并...

于 2022-05-09 发布 文件大小:137.59 kB
0 151
下载积分: 2 下载次数: 1

代码说明:

自动升降电梯控制器设计 要求: 设计一个6层楼的电梯控制器。 该控制器可控制电梯完成6层楼的载客服而且遵循方向优先原则,并能响应提前关门延时关门,并具有超载报警和故障报警; 同时指示电梯运行情况和电梯内外请求信息。-Auto-Lift elevator controller design requirements: design of a six-story elevator controller. The controller can control the completion of six-story elevator containing the principle of giving priority customer service, and follow the directions, and can respond to close ahead of schedule delay closing, and has overload alarm and fault alarm also instructed the elevator and elevator operation request information both inside and outside.

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 通过7路AD转换,结果存至相应存储单元
    通过7路AD转换,结果存至相应存储单元--Convert by 7 route AD, and store the result in corresponding memory.
    2022-07-14 04:23:34下载
    积分:1
  • ARM7开发板的DMA测试程序,这个测试程序用C语言编写。
    一个arm7开发板上的dma测试程序,此测试程序用c语言编写。-a arm7 development board dma test program, this test program using c language.
    2022-09-16 08:30:03下载
    积分:1
  • Extertanl 中断 STM32 stm32cube
    该项目是用 STM32cube 创建并实施 stm32f429 发现板上。基本上,代码等待中断从用户按钮和指示灯亮起
    2023-02-08 09:55:06下载
    积分:1
  • 飞思卡尔DZ60内部晶振校准
    在使用飞思卡尔单片机DZ60时发现,使用用它内部晶振时,串口无法通信,查其原因并分析后得出的结论是内部晶振误差较大,需要校准,本代码通过使用串口通信来得出晶振校准值,使用该校准值后,串口波特率为9600能很好的通信
    2023-08-17 10:30:04下载
    积分:1
  • 二次开发损伤代码
    资源描述用于ABAQUS二次开发的损伤本构模型,有需要的可以下载
    2023-01-18 19:50:04下载
    积分:1
  • uClinux2.6上兼容PRISM2.0芯片组的USB设备驱动程序.
    uClinux2.6上兼容PRISM2.0芯片组的USB设备驱动程序.-uClinux2.6 on PRISM2.0 chipset compatible with the USB driver.
    2022-05-31 14:09:36下载
    积分:1
  • MinGW5 在线安装程序,用于在Windows下编译QT程序
    MinGW5 在线安装程序,用于在Windows下编译QT程序-Online MinGW5 Setup for the Windows compile QT under the procedures
    2023-06-01 21:30:03下载
    积分:1
  • Source code for External memory interfacing for silabs C8051F120
    Source code for External memory interfacing for silabs C8051F120
    2022-02-09 14:15:04下载
    积分:1
  • 8051 works in 11.0592MHZ, RAM expansion for the 128KB of 628128, FlashRom extend...
    8051工作于11.0592MHZ,RAM扩展为128KB的628128,FlashRom扩展为128KB的AT29C010A 128KB的RAM分成4个区(Bank) 地址分配为0x0000-0x7FFF 128KB的FlashRom分成8个区(Bank) 地址分配为0x8000-0xBFFF 为了使8051能访问整个128KB的RAM空间和128KB的FlashRom空间,在CPLD内建两个寄存器 RamBankReg和FlashRomBankReg用于存放高位地址-8051 works in 11.0592MHZ, RAM expansion for the 128KB of 628128, FlashRom extended AT29C010A 128KB to 128KB of the RAM is divided into four zones (Bank) Address Assignment for the 0x0000-0x7FFF 128KB FlashROM divided into eight zones (Bank) Address Assignment for the 0x8000- 0xBFFF in order to enable the 8051 to access the entire 128KB and 128KB of RAM space of FlashROM space, two built-in CPLD register RamBankReg and used to store high FlashRomBankReg Address
    2022-05-30 14:55:40下载
    积分:1
  • Discussing embedded systems in general is difficult, because each embedded syste...
    Discussing embedded systems in general is difficult, because each embedded system is unique. Rather than presenting a list of general principles for handling embedded development issues, this book presents examples of problems encountered and solutions to those problems using real hardware and software. In that sense, it is a “cookbook” for developers that offers design “recipes” that can be elaborated on or modified as needed to solve other design problems.
    2022-02-14 10:49:17下载
    积分:1
  • 696518资源总数
  • 106140会员总数
  • 8今日下载