-
MSP430 F149的单片机 键盘 便于相应计时器的操作
MSP430 F149的单片机 键盘 便于相应计时器的操作-MSP430 F149 microcontroller keyboard to facilitate operation of the corresponding timer
- 2022-05-27 05:11:39下载
- 积分：1
-
用凌阳16位单片机测试输入波形的频率，动态刷新显示
用凌阳16位单片机测试输入波形的频率，动态刷新显示-Sunplus 16-bit single-chip microcomputer used to test the frequency of input waveform, dynamic refresh display
- 2023-05-17 07:25:03下载
- 积分：1
-
on MAX7219 and TLC2543 Data Acquisition System
关于MAX7219与TLC2543的数据采集系统-on MAX7219 and TLC2543 Data Acquisition System
- 2022-12-02 23:15:03下载
- 积分：1
-
driving a TFT screen for the driver, the use of IC : 1828. program (no EEPROM no...
一个用于驱动TFT屏的驱动程序,使用IC:1828,program (无EEPROM 无IR,完整说明)IIC只写一个-driving a TFT screen for the driver, the use of IC : 1828. program (no EEPROM non-IR, a complete explanation) just write a IIC
- 2023-08-24 10:40:03下载
- 积分：1
-
课程设计做的基本程序，可实现串口通信，定时，键盘扫描等功能！...
课程设计做的基本程序，可实现串口通信，定时，键盘扫描等功能！-Curriculum design to do the basic procedures can realize serial communication, timing, keyboard scanning and other functions!
- 2023-04-02 17:55:02下载
- 积分：1
-
This procedure is simple 12232F
本程序为简单的12232F型LCD液晶显示及键盘功能程序
K1键为进入调整，进入后显示四个0，再次按下为退出调整，初始状态 为首行显示河北工程大学
K2键为进入调整后加一
K3键为进入调整后减一
K4键为光标右移 -This procedure is simple 12232F-LCD liquid crystal display and keyboard function keys for entry into the program K1 adjust, enter the show after four 0, once again press for the withdrawal adjust, line shows the initial state, headed by Hebei University of Engineering K2 adjust keys for entry into the after One key for entry into the K3 adjusted by one for the cursor keys K4 shifted to right
- 2023-01-31 19:00:03下载
- 积分：1
-
串口通信的光纤调制解调产品“光猫”的AT89C2051单片机完整源代码及其说明...
串口通信的光纤调制解调产品“光猫”的AT89C2051单片机完整源代码及其说明-serial communication fiber modem products "- cat" AT89C2051 integrity of the source code and its description
- 2022-01-24 09:06:41下载
- 积分：1
-
USB2.0数据采集板原理图,用的是isp1581
USB2.0数据采集板原理图,用的是isp1581-USB data acquisition board schematics, using the isp1581
- 2022-07-10 05:08:06下载
- 积分：1
-
一个320*240的液晶的C51驱动，程序不光可以用在51单片机上，还可以应用在其他单片机上，已成功移植到MSP430，移植时只需要重新改下引脚定义...
一个320*240的液晶的C51驱动，程序不光可以用在51单片机上，还可以应用在其他单片机上，已成功移植到MSP430，移植时只需要重新改下引脚定义-A 320* 240 LCD drive the C51, the program not only can be used in single-chip microcomputer 51, but also can be applied to other single-chip, this has been successfully transplanted into MSP430, transplantation need to change only the definition of under-pin
- 2022-02-16 00:58:34下载
- 积分：1
-
欧几里德算法：辗转求余 原理: gcd(a,b)=gcd(b,a mod b) 当b为0时,两数的最大公约数即为a getchar()会接受前一个scan...
欧几里德算法：辗转求余 原理: gcd(a,b)=gcd(b,a mod b) 当b为0时,两数的最大公约数即为a getchar()会接受前一个scanf的回车符-Euclidean algorithm: Principles of travel for more than: gcd (a, b) = gcd (b, a mod b) when b is 0, the two common denominator is the number of a getchar () will accept the previous scanf carriage return
- 2023-01-01 06:00:05下载
- 积分：1
