登录
首页 » SCM » 机械产品控制器,控制了变频器,并且接入了很多开关量信号

机械产品控制器,控制了变频器,并且接入了很多开关量信号

于 2022-05-28 发布 文件大小:6.14 kB
0 76
下载积分: 2 下载次数: 1

代码说明:

机械产品控制器,控制了变频器,并且接入了很多开关量信号-mechanical products controller, control of the converter, and a lot of access off Signal

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 我用单片机8952和电压比较器339做了一个简单的电容容量测量表,参数大 致如下: 电容测量范围为1pF...
    我用单片机8952和电压比较器339做了一个简单的电容容量测量表,参数大 致如下: 电容测量范围为1pF-9999.99uF,最小分辨力为1pF。分为5个量程,可以自 动切换量程,也可手动切换。 另外,有简单的频率计功能,能测量0-60MHz的数字信号频率(TTL电平); 还可以产生几个单点频率的方波信号(比如1KHz)。 采用1602LCD作为显示器;4个按键控制;使用24C01保存当前设置值,不用 每次开机重新设置。可单5V供电,也可9V交流供电 -I used the single-chip 8952 and the voltage comparator 339 to do a simple capacitance measurement table, parameters are as follows: capacitance measurement range 1pF-9999.99uF, the minimum resolution for the 1pF. Divided into five ranges, you can automatically switch range can also be manually switched. In addition, a simple frequency meter function, capable of measuring 0-60MHz frequency digital signal (TTL level) can also lead to several single-point-frequency square-wave signal (for example, 1KHz). 1602LCD used as a monitor 4 button control use 24C01 to preserve the current settings, do not reset each boot. Can be a single 5V power supply, 9V AC power supply can also be
    2023-08-10 15:10:03下载
    积分:1
  • C51写的串口编程的范例,写串口的兄弟可以参考!
    C51写的串口编程的范例,写串口的兄弟可以参考!-C51 write serial programming paradigm, write serial port can refer to the brothers!
    2022-04-10 23:55:13下载
    积分:1
  • 高质量的18b20,显示非常清晰,而且使用1602显示,方便,实惠,值得推荐...
    高质量的18b20,显示非常清晰,而且使用1602显示,方便,实惠,值得推荐
    2022-03-11 14:24:19下载
    积分:1
  • 单片机程序在线设计 单片机程序在线设计
    单片机程序在线设计 单片机程序在线设计-Single-chip Single-chip design process online program online online design single-chip design process
    2022-04-08 02:37:30下载
    积分:1
  • HT24 系列的EEPROM 总共8 个管脚,三个为芯片地址脚A0、A1、A2,在单片机对它进行操作时,从SDA 输入A0、A1、A2 数据和芯片外部A0、A1...
    HT24 系列的EEPROM 总共8 个管脚,三个为芯片地址脚A0、A1、A2,在单片机对它进行操作时,从SDA 输入A0、A1、A2 数据和芯片外部A0、A1、A2 所接地址需一一对应。一个为芯片写保护脚WP,WP 脚接低电平时,芯片可进行读写操作;WP 脚接高时,芯片只可进行读,不可进行写。 另外两个管脚为电源脚VCC,VSS。 用单片机对HT24 系列的EEPROM 进行控制时,HT24 系列的EEPROM 的外部管脚VCC、VSS、WP、A0、A1、A2 根据需要,对应接上,SDA、SCL 接到单片机控制脚上。-HT24 Series EEPROM total of 8 pins, three pins for the chip address A0, A1, A2, in the microcontroller to operate it, from SDA input A0, A1, A2, and chip external data A0, A1, A2 of the Then one correspondence address must be in. One for the chip, write-protect pin WP, WP feet then low, the chip can be read and write operations WP pin is high then, the chip can only be read, not write. The other two pins for the power pin VCC, VSS. With the microcontroller on the HT24 Series EEPROM control when, HT24 Series EEPROM external pin VCC, VSS, WP, A0, A1, A2 according to the needs of the corresponding connected, SDA, SCL receives SCM control feet .
    2022-01-28 04:45:28下载
    积分:1
  • DDS数字信号发生器,采用AD9835DDS 专用芯片 输出范围1K
    DDS数字信号发生器,采用AD9835DDS 专用芯片 输出范围1K--10MHZ 采用X25045作看门狗及数据存储器,用于设置各项参数的存储 内含电路图, 源程序 及一些相关资料-DDS digital signal generator, using AD9835DDS ASIC output range 1K-- Knoxville watchdog for the use of X25045 and data memory, used to set various parameters of storage containing circuit, the source and related information
    2023-01-16 17:05:04下载
    积分:1
  • 这是一篇关于嵌入式系统的LCD液晶驱动程序的资料及源程序
    这是一篇关于嵌入式系统的LCD液晶驱动程序的资料及源程序-This is an embedded system on the LCD driver and source of information
    2022-01-21 02:33:35下载
    积分:1
  • AT89S51 microcontroller system to the core, the use of single
    系统以AT89S51单片机为核心,利用单片机可根据实际的需要随时更改程序而实现功能的改变。包含程序和课程设计文章-AT89S51 microcontroller system to the core, the use of single-chip microcomputer according to actual need to change procedures and the achievement of functional change. Contains the procedures and curriculum design articles
    2022-07-16 20:12:17下载
    积分:1
  • 介绍用单片机实现时钟的程序,可共大家学习,交流.
    介绍用单片机实现时钟的程序,可共大家学习,交流.-Introduced with MCU clock procedures, a total of U.S. study, the exchange.
    2023-08-26 12:45:03下载
    积分:1
  • 单片机编程的bcd码和hex码的互换,BCD2HEX 例子: c=BCD2HEX(0x255) //255 转成HEX为0xff c=HE...
    单片机编程的bcd码和hex码的互换,BCD2HEX 例子: c=BCD2HEX(0x255) //255 转成HEX为0xff c=HEX2BCD(0xff) //0xff 转成BCD码为 2-microcontroller programming bcd yards and hex code swap BCD2HEX example : c = BCD2HEX (0x255)// 255 to HEX conversion c = 0xff HEX2BCD (0xff)// 0xff conversion of 255 BCD
    2023-02-28 18:45:03下载
    积分:1
  • 696518资源总数
  • 105739会员总数
  • 1今日下载