-
常用串行EEPROM的编程应用，EEPROM是"Electrically Erasable Programmable Read...
常用串行EEPROM的编程应用，EEPROM是"Electrically Erasable Programmable Read-only"（电可擦写可编程只读存储器）的缩写，EEPROM在正常情况下和EPROM一样，可以在掉电的情况下保存数据，所不同的是它可以在特定引脚上施加特定电压或使用特定的总线擦写命令就可以在在线的情况下方便完成数据的擦除和写入-Commonly used application of serial EEPROM programming, EEPROM is Electrically Erasable Programmable Read-only (Xinhua EPROM) acronym, EEPROM under normal circumstances and EPROM, as in the case of power-down to save data , What is different is that it can exert in a particular pin on a specific voltage or use specific bus write command can be in the case of online data to facilitate the completion of the erase and write
- 2022-01-23 11:15:59下载
- 积分：1
-
HT1621的C51版C语言驱动
HT1621的C51版C语言驱动-HT1621 C51 version of the C language drive
- 2022-07-12 01:29:31下载
- 积分：1
-
ADUC845 SCM some C procedures, including AD and DA, timers, etc.
ADUC845单片机的一些C程序，包括AD、DA 、定时器等-ADUC845 SCM some C procedures, including AD and DA, timers, etc.
- 2022-01-31 04:25:11下载
- 积分：1
-
利用动态扫描和定时器1在数码管上显示
出从765432开始以1/10秒的速度往下递减
直至765398并保持显示此数，与此同时利
用定时器0以500...
利用动态扫描和定时器1在数码管上显示
出从765432开始以1/10秒的速度往下递减
直至765398并保持显示此数，与此同时利
用定时器0以500MS速度进行流水灯从上至
下移动，当数码管上数减到停止时，实验
板上流水灯也停止然后全部开始闪烁，3秒
后（用T0定时）流水灯全部关闭、数码管上
显示出"HELLO"。到此保持住。
设晶振频率为12MHz。-The use of dynamic scanning and Timer 1 in the digital control to show from the beginning of 765,432 to 1/10 seconds until the speed of descending down 765,398 and maintain display this number, at the same time the use of Timer 0 to 500ms the speed of light from the flowing water to Under the move, when reduced to a few digital tube stop, the experiment on-board water stop and then all the lights started to flicker, 3 seconds later (T0 regularly used) closed water lights, digital tubes show
- 2022-02-03 00:14:56下载
- 积分：1
-
ADC0809数据采集程序，适合与51系列单片机系统。
ADC0809数据采集程序，适合与51系列单片机系统。-ADC0809 data acquisition procedures, suitable for single-chip microcomputer system with 51 series.
- 2022-06-19 18:21:39下载
- 积分：1
-
Hardware needed to develop liquid crystal display module 1602 required the user....
开发硬件电路需要用到液晶显示模块1602的用户必备。调试实验源程序第一部分。-Hardware needed to develop liquid crystal display module 1602 required the user. Debug source code the first part of the experiment.
- 2022-05-30 03:54:23下载
- 积分：1
-
51单片机产生锯齿波的程序
51单片机产生锯齿波的程序-51 SCM procedures have Sawtooth
- 2022-01-21 21:40:44下载
- 积分：1
-
A 89c52 single
一个在89c52单片机上实现的多路温度采集通信程序-A 89c52 single-chip to achieve the multi-channel temperature acquisition Communication Program
- 2022-08-12 20:33:45下载
- 积分：1
-
这里有武汉恒科 51 单片机仿真器附带的约 80 个 ASM 示例代码,初学 51 单片机汇编的可以有各种示例....
这里有武汉恒科 51 单片机仿真器附带的约 80 个 ASM 示例代码,初学 51 单片机汇编的可以有各种示例.-There, Wuhan Hengke 51 MCU emulator with about 80 ASM sample code, beginner 51 microcontroller There are various examples that can be compiled.
- 2022-09-01 23:10:03下载
- 积分：1
-
Very useful on the MSP430 MCU lot of very good source
很有用的关于msp430单片机的很多很好的源程序-Very useful on the MSP430 MCU lot of very good source
- 2022-12-14 18:40:08下载
- 积分：1
