登录
首页 » SCM » 单片机AT90S系列 制作简易USB接口(软件模拟,无usb硬件)。

单片机AT90S系列 制作简易USB接口(软件模拟,无usb硬件)。

于 2022-07-08 发布 文件大小:62.66 kB
0 110
下载积分: 2 下载次数: 1

代码说明:

单片机AT90S系列 制作简易USB接口(软件模拟,无usb硬件)。- Monolithic integrated circuit AT90S series manufacture simple USB connection (software simulation, non- usb hardware).

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • C语言写的日历时间程序。采用51单片机。
    C语言写的日历时间程序。采用51单片机。-C language writes calendar time sequencing. Uses 51 monolithic integrated circuits.
    2022-01-26 05:22:26下载
    积分:1
  • 具有固定的“红灯―绿灯”转换间隔,并自动切换。它们一般由“通行与禁止时间控制显示、红黄绿三色信号灯和方向指示灯”三部分组成。在交通灯的通行与禁止时间控制显示中,...
    具有固定的“红灯―绿灯”转换间隔,并自动切换。它们一般由“通行与禁止时间控制显示、红黄绿三色信号灯和方向指示灯”三部分组成。在交通灯的通行与禁止时间控制显示中,通常要么东西、南北两方向各50秒;要么根据交通规律,东西方向60秒,南北方向40秒,时间控制都是固定的。交通灯的时间控制显示,以固定时间值预先“固化”在单片机中,每次只是以一定周期交替变化。-having fixed the "red light-green light" switch partitions, and automatic switching. They are generally from "prohibiting access and time control, red-yellow-green lights and direction indicator" is composed of three parts. Traffic lights in the passage of time and prohibit control indicates that things are usually either the north-south direction of the two 50 seconds; either on the basis of traffic laws, an east-west direction 60 seconds, 40 seconds north-south direction, the time control are fixed. Traffic lights to the time control, a pre-fixed time value "cured" in SCM, each is a certain cycle alternation.
    2022-01-25 16:49:25下载
    积分:1
  • 用51单片机内部定时器实现数字钟功能,可以显示小时,分,秒,误差很小。...
    用51单片机内部定时器实现数字钟功能,可以显示小时,分,秒,误差很小。-51 single-chip microcomputer with internal timer digital clock function, can display hours, minutes and seconds, the error small.
    2022-04-24 17:53:48下载
    积分:1
  • C8051F020 and pressure sensor produced HP03S pressure tester, serial communicati...
    C8051f020与气压传感器HP03S制作的气压测试仪,串口与PC机通讯。Keil工程打包。-C8051F020 and pressure sensor produced HP03S pressure tester, serial communication with PC. Keil engineering package.
    2022-02-07 20:12:16下载
    积分:1
  • PIC16F877控制LED进行任何显示,该源码只做了北京两个字的显示...
    PIC16F877控制LED进行任何显示,该源码只做了北京两个字的显示-PIC16F877 to control LED of any revealed that the source only the word display in Beijing
    2022-07-23 14:16:00下载
    积分:1
  • 三菱16位单片机M306N0系列,CAN
    三菱16位单片机M306N0系列,CAN-BUS驱动源码。-Mitsubishi 16-bit microcontroller M306N0 series, CAN-BUS driver source code.
    2023-07-17 00:40:03下载
    积分:1
  • IC Card operating software : AT88SCl604 chip mode of operation there are five. T...
    IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作: AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位: 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位: 当CLK为低时,在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位,而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta
    2022-05-28 08:23:00下载
    积分:1
  • JTAG 提供了简单易行的调试手段。该软件提供了简易AVR jtag迪的制作方法...
    JTAG 提供了简单易行的调试手段。该软件提供了简易AVR jtag迪的制作方法-offers a simple JTAG debugging tools. The software provides a simple JTAG Di AVR Method of Making
    2023-06-07 07:40:03下载
    积分:1
  • 8051 control CF CARD
    8051 control CF CARD
    2022-03-12 16:36:01下载
    积分:1
  • 单片机78P156
    MCU:78p156 driver: adi-GSENSOR
    2022-07-24 17:02:44下载
    积分:1
  • 696518资源总数
  • 105540会员总数
  • 37今日下载