51单片机控制两路步进电机,实现各种工作方式及其转换-51 MCU control two stepper motor road to achieve various methods of work and its conversion

利用单片机控制实现的计算器，用lcd显示计算的过程和结果。-SCM control to achieve use of calculator, lcd display with the calculation process and results.

英飞凌C166之XC164CS串口通讯程序-Infineon C166

虚拟声卡的详细说明！有一个虚拟声卡示波器，现在大量使用，并链接到地图与您分享！

MSP430系列单片机串口通讯波特率计算工具-MSP430 MCU serial communication baud rate calculation tool

本程序为数码管显示处理模块 占用I/O RC3,RC4,RC5 使用RAM 节 程序包括: InitSPI 初始化SPI子程序 LEDlight 送七段码显示子程序 入口参数 LED_DATA 出口参数 无-This procedure for the digital display processing module occupied I/O RC3, RC4, RC5 use RAM section include: InitSPI initialize SPI sent to Seven-Segment Subroutine LEDlight code display subroutine parameter exports LED_DATA entrance parameters without

c8051f020 cp1 的简单应用 -c8051f020 cp1 simple application

p87lpc762单片机处理红外遥控信号-p87lpc762 SCM infrared remote control signal processing

12864LCD电子钟c语言程序，电子钟的经典之作-12864LCD electronic bell c language program, the electronic bell classic

本设计以P89V51RD2FN单片机为电动小车的控制核心，采用MSA-LD2.0倾角传感器实时测量跷跷板的倾斜角，用ST198光电传感器检测黑色引导线监测小车运动。光电传感器和倾角传感器模块把实时测量信号馈送至单片机，利用专用细分芯片TA8435H驱动步进电机，以脉宽调制式斩波方式对步进电机步进角进行细分，控制和调节小车速度。采用增量式PID控制算法确保小车能够达到平衡；用RT128×64M液晶显示时间、角度等参数。经测试表明：小车各项性能指标达到设计要求，能够实现30秒内小车行驶到规定点，并保持跷跷板平衡；在跷跷板一端配重可调整的情况下，小车也能自动找到平衡点并保持跷跷板平衡。-The single-chip design for the electric car P89V51RD2FN control of the core, the MSA-LD2.0 seesaw angle sensor real-time measurement of the tilt angle, the detection of black ST198 photoelectric sensor to monitor vehicle movement and guide lines.Photoelectric sensors and angle sensors in real-time measurement module to feed the signal to the microcontroller, using a dedicated sub-chip stepper motor driver TA8435H to PWM chopper-type stepper motor on the sub-stepping angle, control and regulation vehicle speed. The use of incremental PID control algorithm to ensure that the car can achieve balance with LCD RT128 × 64M time, angle and other parameters.After the test showed that: the performance car