-
用单片机控制max7219做的led灯的动态显示
用单片机控制max7219做的led灯的动态显示-Max7219 control with single-chip led lamps do dynamic display
- 2022-04-01 22:31:31下载
- 积分：1
-
SPC3 PROGRAMS
SP C3 PROGRAMS
SPC3 PROGRAMS
SP C3 PROGRAMS
- 2022-01-26 00:51:40下载
- 积分：1
-
发光板
Luminary cotex-M3 CAN总线 源代码-Luminary cotex-M3 CAN bus source code
- 2023-02-09 08:15:04下载
- 积分：1
-
用AT89S51单片机实现LCD1602显示数字时钟功能，通过按键能调节时分秒、年月日星期。Keil C51开发环境...
用AT89S51单片机实现LCD1602显示数字时钟功能，通过按键能调节时分秒、年月日星期。Keil C51开发环境-AT89S51 MCU LCD1602 display with digital clock function, through the buttons can be conditioned every minute, day of week. Keil C51 Development Environment
- 2022-03-18 05:33:37下载
- 积分：1
-
控制电机运动的G代码程序,如果对G代码不清楚,请先看懂G代码,然后再看本程序....
控制电机运动的G代码程序,如果对G代码不清楚,请先看懂G代码,然后再看本程序.-Control motor movement, G code program, if the G code is not clear, please understand G code, and then look at the procedures.
- 2023-09-08 17:15:03下载
- 积分：1
-
本设计以P89V51RD2FN单片机为电动小车的控制核心，采用MSA
本设计以P89V51RD2FN单片机为电动小车的控制核心，采用MSA-LD2.0倾角传感器实时测量跷跷板的倾斜角，用ST198光电传感器检测黑色引导线监测小车运动。光电传感器和倾角传感器模块把实时测量信号馈送至单片机，利用专用细分芯片TA8435H驱动步进电机，以脉宽调制式斩波方式对步进电机步进角进行细分，控制和调节小车速度。采用增量式PID控制算法确保小车能够达到平衡；用RT128×64M液晶显示时间、角度等参数。经测试表明：小车各项性能指标达到设计要求，能够实现30秒内小车行驶到规定点，并保持跷跷板平衡；在跷跷板一端配重可调整的情况下，小车也能自动找到平衡点并保持跷跷板平衡。-The single-chip design for the electric car P89V51RD2FN control of the core, the MSA-LD2.0 seesaw angle sensor real-time measurement of the tilt angle, the detection of black ST198 photoelectric sensor to monitor vehicle movement and guide lines.Photoelectric sensors and angle sensors in real-time measurement module to feed the signal to the microcontroller, using a dedicated sub-chip stepper motor driver TA8435H to PWM chopper-type stepper motor on the sub-stepping angle, control and regulation vehicle speed. The use of incremental PID control algorithm to ensure that the car can achieve balance with LCD RT128 × 64M time, angle and other parameters.After the test showed that: the performance car
- 2023-09-02 02:10:04下载
- 积分：1
-
ATmega16 procedures, controls 1602 LCD with only six I/O ports, I' ve simulat...
ATmega16程序，控制1602液晶，只用了六个I/O口，我仿真过的，没有错误，而且还带Pretues图。-ATmega16 procedures, controls 1602 LCD with only six I/O ports, I" ve simulation, there are no errors, but also with Pretues map.
- 2022-07-06 12:02:41下载
- 积分：1
-
PS2键盘设计
PS2键盘设计---C51程序，详细介绍了对PS2键盘的响应和处理-PS2 keyboard design-C51 procedure, described in detail on the PS2 keyboard response and treatment
- 2022-07-11 19:49:34下载
- 积分：1
-
We design fire alarm, and basically meet the requirements of everyone can refer...
我们设计的火灾报警器，基本上满足要求，大家可以参考-We design fire alarm, and basically meet the requirements of everyone can refer to
- 2022-08-25 16:11:42下载
- 积分：1
-
NRF9E5 chips prepared using C51 source code, can be achieved to receive part of...
利用NRF9e5芯片编写的C51源代码，可实现点到点无线通信接收部分。-NRF9E5 chips prepared using C51 source code, can be achieved to receive part of point-to-point wireless communications.
- 2023-07-17 23:35:03下载
- 积分：1
