-
请将下载的2个插件内容拷贝到uVision 的安装目录下的 KeilC51BIN 中
2. 修改 Tool.ini, 此文件位于 uVision 的...
请将下载的2个插件内容拷贝到uVision 的安装目录下的 KeilC51BIN 中
2. 修改 Tool.ini, 此文件位于 uVision 的安装目录 keil 下.
请将下面的内容 添加到 [C51] 部分的后面.
AGSI1=ledkey.dll ("ledkey")
AGSI2=simboard.dll ("simboard")
3. 重启uVsion. 进入Debug 模式, 打开菜单Peripheral, 发现增加了2项
分别是键盘LED仿真板，51实验仿真板。-Please download the contents of two plug-ins are copied to the installation directory uVision under KeilC51BIN 2. Modify Tool.ini, this file is located in the installation directory uVision under keil. Please Add the following line to [C51] part of the back. AGSI1 = ledkey.dll (ledkey) AGSI2 = simboard.dll (simboard) 3. Reset uVsion. entered the Debug mode, open the menu Peripheral, found an increase of 2 are keyboard LED emulation board, emulation board 51 experiments.
- 2022-07-16 18:54:59下载
- 积分：1
-
Serial communication program, sending instead of interrupt mode, receive mode us...
串行通信程序，发送不是用中断方式，接收用中断方式，适用于程序的调试，液晶显示用的是1602-Serial communication program, sending instead of interrupt mode, receive mode using interrupted for Debugging, liquid crystal display using 1602
- 2023-08-19 16:05:03下载
- 积分：1
-
这是DSP2407的RAM测试程序,含全部源码,调试通过,可运行.
这是DSP2407的RAM测试程序,含全部源码,调试通过,可运行.-This is the DSP2407 the RAM test procedures, including all source code, debugging is passed, can be run.
- 2023-08-06 12:40:03下载
- 积分：1
-
STM32F103 cortex
STM32F103 cortex-m3
can总线例程-STM32F103 cortex-m3can bus routines
- 2023-06-13 08:10:03下载
- 积分：1
-
单片机控制液晶显示的源代码。8051
单片机控制LCD显示的源代码。控制器兼容8051系列芯片，包括原理图。-SCM control LCD display the source code. 8051-compatible controller chips, including schematics.
- 2022-09-18 14:35:03下载
- 积分：1
-
uPSD34xx Disk driver
uPSD34xx Disk driver
- 2022-01-25 14:34:11下载
- 积分：1
-
C8051
c8051-nrf2401 测试程序 发送部分-NRF2401_receive2 c8051f330
- 2022-03-20 13:24:59下载
- 积分：1
-
C8051F120初始化SPI，启动CC2420。通过将CC2420 得VREG_EN 引脚置位高电平使能Voltage
regulator，等待其稳定；然...
C8051F120初始化SPI，启动CC2420。通过将CC2420 得VREG_EN 引脚置位高电平使能Voltage
regulator，等待其稳定；然后重新启动CC2420 芯片，等待晶振起振。-Initialize SPI, start the CC2420. By CC2420 have VREG_EN pin high to enable the set Voltage regulator, waiting for their stability and then re-start the CC2420 chip, since waiting for crystal oscillator.
- 2022-09-03 13:40:03下载
- 积分：1
-
自己写的STM32的串口驱动，没有固件库。超级终端界面…
自己写的 STM32 串口UART驱动, 不用固件库。超级终端界面按键时,自动回送。
应用范围: 因为不涉及IO口,所以此工程在STM32F1xx的任何主板上都可以运行。
编译器: IAR ARM 4.42A。
作者: w123456xy@sohu.com 15189792379。
-Write your own STM32 serial UART driver, no firmware library. HyperTerminal interface button, automatically send back. Application scope: because they do not involve IO port, so this works on any STM32F1xx motherboard can run. Compiler: IAR ARM 4.42A. Author: w123456xy@sohu.com 15189792379.
- 2022-07-25 10:20:01下载
- 积分：1
-
在软件proteus下仿真MCU
在软件proteus下仿真MCU-51单片机6位LED计数器的演示例子和完整源代码(keil工程)-in software simulation under MCU-51 6 LED counter demonstration examples and complete source code (c51 engineering)
- 2022-01-22 14:03:56下载
- 积分：1
