-
数字电子钟程序，计时时、分、秒，手动调整时间，闹铃，和整点报时...
数字电子钟程序，计时时、分、秒，手动调整时间，闹铃，和整点报时-digital electronic clock procedures, a time when, minutes, and seconds, manual adjustments, Alarms, and the whole point is true.
- 2022-07-21 07:02:51下载
- 积分：1
-
用数码管显示测得的心率值。并控制发光二极管的亮灭。
用数码管显示测得的心率值。并控制发光二极管的亮灭。-Digital display of heart rate measured value. And control of light to eliminate light-emitting diodes.
- 2022-04-22 00:05:18下载
- 积分：1
-
用c51编写写的x25045的读写程序，
用c51编写写的x25045的读写程序，-used to prepare written procedures x25045 reader,
- 2022-09-04 02:45:03下载
- 积分：1
-
AT89S51 MCU Output Pulse Width Modulation Wave
AT89S51单片机 输出Pulse Width Modulation Wave -AT89S51 MCU Output Pulse Width Modulation Wave
- 2023-09-09 22:00:03下载
- 积分：1
-
本文档是翻译后的ATMEL的8bit单片机atmega16l的中文数据手册，供参考...
本文档是翻译后的ATMEL的8bit单片机atmega16l的中文数据手册，供参考-this document is the chinese spec of atmega16l
- 2022-03-20 10:58:21下载
- 积分：1
-
Sunplus LCD presentation of the original code, along with LCD instructions.
凌阳的LCD演示原码,里面还有LCD的使用说明.-Sunplus LCD presentation of the original code, along with LCD instructions.
- 2022-05-29 11:32:34下载
- 积分：1
-
The design of single
本设计的由单片机控制的自动加料系统是与料斗式干燥机配套的加料系统。根据加料工艺要求，其工作原理是：先将真空管关闭，启动电机，用低真空气流将塑料树脂粒子送入真空管，电机停转，再将粒子排入料斗，如此循环。-The design of single-chip microcomputer controlled by the automatic feeding system with hopper dryer feed supporting system. Charging process in accordance with the requirements of its working principle is: first vacuum tube to close, start motor, using low vacuum plastic resin particles will flow into the vacuum tube, the electrical switch to stop, and then particles into the hopper, and so the cycle.
- 2022-05-27 04:59:44下载
- 积分：1
-
信号滤波，使用在AVR.
串口接收数据格式 0xFFFF+数据位。
信号滤波，使用在AVR.
串口接收数据格式 0xFFFF+数据位。-Signal filtering, the use of the AVR. Serial receive data format 0xFFFF+ Data bit.
- 2022-08-23 20:40:57下载
- 积分：1
-
a micro
一个微型打印机C51控制程序，希望对大家有用-a micro-C51 printer control procedures in the hope that it may be useful to
- 2023-06-27 09:45:03下载
- 积分：1
-
system can address 550 for the test system can, Application T0 1s to every timer...
系统can地址为550,用于can系统测试,应用T0定时器每隔1s向can总线发送一组数据:数据长度为8个字节,
首字节为05H,第二个字节为累加变量,每秒钟数值增加1,-system can address 550 for the test system can, Application T0 1s to every timer can send a bus of data : data length of 8 bytes the first byte of 05H, the second byte of cumulative variable, an increase in value per second.
- 2022-02-14 22:03:01下载
- 积分：1
