用VC++编写的USB接口通信程序，供大家参考，-用VC++ ?嘈

usb host 主机开发的硕士论文1-usb host mainframe development of a master"s thesis

usb协议的正式规范，必备-usb agreement formalized Obligatory

ARM7+D12开发U盘的资料(中pdf)_老古开发网下载特区-ARM7+ D12 Development U disk information (in pdf) _ nerd Development Network to download the SAR

Usb camera frame render library

mp3设计程序资料，采用c语言编写。 README file for yampp-3 source code 2001-05-27 This is the current state of the yampp-3 source code, 2001-05-27. This code is intended to run on Rev. B of the yampp-3 PCB, but can ofcourse be used on compatible systems as well. It still uses the "old" song selection system as the yampp-2. However, the disk handling routines has improved a lot and the obviosly, the new VS1001 handling has been put in. The codesize is almost at it s maximum at 1F40 bytes. A .ROM file is included if you don t have the compiler set up. For now, the documentation is in the code- mp3 programming cook book in C. README file for yampp-3 source code 2001-05-27 This is the current state of the yampp-3 source code, 2001-05-27. This code is intended to run on Rev. B of the yampp-3 PCB, but can ofcourse be used on compatible systems as well. It still uses the "old" song selection system as the yampp-2. However, the disk handling routines has impr

使用68013的测试程序，包含68013固件程序（采用slave FIFO bulk同步读写，EP2 OUT，EP6 IN），驱动，PC端测试用程序。CPLD的VHDL代码-Test procedures for the use of 68,013, including 68,013 firmware (using the synchronous slave FIFO bulk read and write, EP2 OUT, EP6 IN), driver, PC-side test procedures. VHDL code of CPLD

CH375 USB接口协议芯片MC51平台下的实例程序-CH375 USB interface protocol chip platform MC51 examples of procedures under

This example firmware is based on Microchip s USB Support Firmware. The purpose of this example is to provide a model for making a USB combination device. This mainly entails having the USB descriptors set up correctly. File usb_ch9.c contains the mouse and keyboard descriptors in the correct configuration. The main routine of this example moves the cursor in a circle and sends keyboard keycodes for the message "Microchip USB" over and over again. Some advice: Before running this firmware open a blank text document. Make sure that when you run the device/emulator that you are able to give focus to the document. The cursor will be moving in a circle so make sure you have plenty of room to click on the editor window. This will allow you to see the message "Microchip USB" without inadvertently having the message type over an existing document.-This example firmware is based on Microchip s USB Support Firmware. The purpose of this exampl

这个一个usb接口芯片ch372的，上位机（PC）机程序，用vc编写。-this one usb interface chip ch372, PC (PC) Program, prepared using vc.