-
This procedure is simple 12232F
本程序为简单的12232F型LCD液晶显示及键盘功能程序
K1键为进入调整，进入后显示四个0，再次按下为退出调整，初始状态 为首行显示河北工程大学
K2键为进入调整后加一
K3键为进入调整后减一
K4键为光标右移 -This procedure is simple 12232F-LCD liquid crystal display and keyboard function keys for entry into the program K1 adjust, enter the show after four 0, once again press for the withdrawal adjust, line shows the initial state, headed by Hebei University of Engineering K2 adjust keys for entry into the after One key for entry into the K3 adjusted by one for the cursor keys K4 shifted to right
- 2023-01-31 19:00:03下载
- 积分：1
-
AVR定时器功能
定时器每秒加一,0到255循环,通过数码管显示计数值...
AVR定时器功能
定时器每秒加一,0到255循环,通过数码管显示计数值-AVR timer function Timer per second, plus one, 0 to 255 cycles, through the LED display counts
- 2022-02-02 00:18:50下载
- 积分：1
-
a complete temperature control procedures
一个单片机温度控制的完整程序-a complete temperature control procedures
- 2022-03-15 13:44:15下载
- 积分：1
-
Write your own STM32F10x the ADC and Timer
自己写的 STM32F10x的ADC和Timer驱动, 没有使用固件库。每秒通过串口UART输出当前ADC值。
应用范围: 因为不涉及IO口,所以此工程在STM32F1xx的任何主板上都可以运行。
编译器: IAR ARM 4.42A。
作者: w123456xy@sohu.com 15189792379。
-Write your own STM32F10x the ADC and Timer-driven, not using the firmware library. Second serial UART output current through the ADC value. Application scope: because they do not involve IO port, so this works on any STM32F1xx motherboard can run. Compiler: IAR ARM 4.42A. Author: w123456xy@sohu.com 15189792379.
- 2022-07-11 04:46:01下载
- 积分：1
-
EEPROM芯片驱程
EEPROM芯片驱程-EEPROM chip-way drive
- 2022-02-15 14:24:53下载
- 积分：1
-
6段数码管分别显示，时，分，秒，四个按键，K1（P0.0），K2（P0.1），
K3（P0.2），K4（P0.3），四个按键用来调时间的，按下K1，所有位都...
6段数码管分别显示，时，分，秒，四个按键，K1（P0.0），K2（P0.1），
K3（P0.2），K4（P0.3），四个按键用来调时间的，按下K1，所有位都清零显示，然后按下K2，秒在闪烁，继续按K2分闪烁，不段地按K2 秒--分--时切换着闪烁，在某位闪时按下K3相应位加一，确认调整，按K4，取消调整再按K1。在K1按下以后才有调时的功能，如果K1没有按下，按别的键没有反映。这为了在加点按键功能留着用
-6 respectively of the digital control, when, minutes and seconds, four keys, K1 (P0.0). K2 (P0.1), K3 (P0.2), K4 (width), the four keys to the transfer time, press the K1, All spaces are reset, then press K2, the scintillation seconds, according to K2 pm flickered. not according to K2 of seconds-- minutes-- when switching to flicker in certain press the flash-K3 corresponding increase in a confirmed adjustment by K4, then canceled K1 adjustment. K1 in the press will only be made after the transfer of function, if K1 pressed by other key is not reflected. This points to the function keys used Retention
- 2022-08-13 14:18:02下载
- 积分：1
-
aduc814的汇编程序例子
aduc814的汇编程序例子-ADUC814 example of the compilation process
- 2023-04-03 05:05:03下载
- 积分：1
-
tom is a boy
工程制图是一个非常重要的东东，需要每一个人沉下心来仔细学习-tom is a boy
- 2022-06-12 00:46:45下载
- 积分：1
-
Third Freescale Cup National Smart Automobile Competition second prize are inter...
第三届飞思卡尔杯智能汽车大赛全国二等奖源程序有兴趣的下载来看看。-Third Freescale Cup National Smart Automobile Competition second prize are interested in downloading source code to look at.
- 2022-01-26 06:21:09下载
- 积分：1
-
AD转换器MAX127驱动程序（ KEIL C51 ）
AD转换器MAX127驱动程序（ KEIL C51 ）-AD converters MAX127 driver (KEIL C51)
- 2023-07-19 07:15:04下载
- 积分：1
