-
自己编写的专门针对6122红外编码芯片的红外解码程序,使用定时器+中断,占用CPU时间少,能稳定可靠的解码...
自己编写的专门针对6122红外编码芯片的红外解码程序,使用定时器+中断,占用CPU时间少,能稳定可靠的解码
- 2023-08-30 12:50:03下载
- 积分：1
-
基于ucos
基于UCOS-II制作的MP3，把UCOS-II移植到单片机上-based UCOS-II production of MP3, UCOS-II transplant MCU
- 2022-05-05 00:54:23下载
- 积分：1
-
用于51单片机的12864液晶显示程序（汇编）
用于51单片机的12864液晶显示程序（汇编）-12864 for 51 single-chip liquid crystal display of the program (compilation)
- 2022-08-03 06:10:58下载
- 积分：1
-
MCU AVR mage8 Bootload procedures, full version, I do projects like the use of t...
AVR mage8单片机的bootload程序、完整版本、本人做项目一下在用、此程序为16m晶振版本、非常好用-MCU AVR mage8 Bootload procedures, full version, I do projects like the use of this procedure for the 16m crystal version, very easy to use
- 2022-04-01 00:36:48下载
- 积分：1
-
Seven
实验采用七段码LED设计（数码管），显示直观；采用定时器中断，计时更准确；功能齐全，可随时启动、停止、清零，后者智能化程度更高。-Seven-Segment LED code using the experimental design (digital control), visual display using timer interrupt, a more accurate time functions, may at any time to start, stop, cleared, and the latter an even higher degree of intelligence.
- 2022-02-24 17:23:59下载
- 积分：1
-
一个基于单片机的充电器程序，能冲各种电池，可以设定模式。...
一个基于单片机的充电器程序，能冲各种电池，可以设定模式。-A procedure based on single chip charger can be washed all kinds of batteries, you can set the mode.
- 2022-05-14 05:39:38下载
- 积分：1
-
Single
单片机的串口调试程序，可实现简单的串口通信-Single-chip serial debugging procedures can realize a simple serial communication
- 2022-07-21 07:42:19下载
- 积分：1
-
SD Card source files, users can change the actual hardware
SD卡开发源程序，可根据用户实际硬件修改-SD Card source files, users can change the actual hardware
- 2022-01-25 18:29:59下载
- 积分：1
-
描述：这个多
Discription: This multi-master driver provides the software interface to the
I2C Bus hardware of the M3062x series of MitsubishiMCU.
- 2022-08-03 07:27:43下载
- 积分：1
-
Content:* IR test program, launched with the microcontroller through the launch...
内容：
*红外测试程序，用单片机通过发射管发射38K的调制频率码，由一体化接收并解码由发光管显示。
*正常情况下，由于反射和高灵敏度接收，LED4（P1.3)一直闪烁，可以用黑色纸片完全遮挡接收头使
*之不能接收到发射管的信号，这是LED4熄灭。说明功能性正常
-Content:* IR test program, launched with the microcontroller through the launch tube of the modulation frequency of 38K code, by the integration to receive and decode from the LED display.* Under normal circumstances, due to reflection and high-sensitivity receiver, LED4 (P1.3) has been flickering, you can completely block the black pieces of paper to make* that they are not receiving the first emission control signal is received, it is LED4 out. Note the normal functional
- 2022-03-20 16:16:04下载
- 积分：1
