登录
首页 » SCM » 嵌入式通用EEPROM读写程序.

嵌入式通用EEPROM读写程序.

于 2022-10-03 发布 文件大小:1.43 kB
0 142
下载积分: 2 下载次数: 1

代码说明:

嵌入式通用EEPROM读写程序.-embedded EEPROM read and write common procedures.

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • bios for s3C44B0 ,ads
    bios for s3C44B0 ,ads-bios for s3C44B0, ads
    2022-04-21 15:26:55下载
    积分:1
  • 主要介绍keil的功能及使用方法,并附有相关实例,及源代码
    主要介绍keil的功能及使用方法,并附有相关实例,及源代码-Keil introduces the function and use, together with relevant examples, and source code
    2023-07-23 01:45:05下载
    积分:1
  • IC Card operating software : AT88SCl604 chip mode of operation there are five. T...
    IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作: AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位: 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位: 当CLK为低时,在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位,而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta
    2022-05-28 08:23:00下载
    积分:1
  • C8051F020for162液晶驱动程序,一款类似于51但是比51强大的多的单片机。...
    C8051F020for162液晶驱动程序,一款类似于51但是比51强大的多的单片机。-C8051F020for162 LCD driver, the provision was similar to 51 than 51 but more powerful microcontroller.
    2022-02-25 13:22:17下载
    积分:1
  • fjdkjafkljdljalfld
    温度控制识别 温度控制识别 -fjdkjafkljdljalfld
    2022-01-31 21:40:11下载
    积分:1
  • 利用UP
    利用UP-NETARM3000 嵌入式实验平台上的A/D转换器、直流电机、LED和LCD模拟车辆的里程表盘系统。A/D转换器模拟汽车的油门和变速系统;直流电机模拟汽车发动机;LED显示车辆总里程数;LCD模拟当前车辆的速度-UP-NETARM3000 using experimental platform embedded A/D converters, DC motor, LED and LCD odometer vehicles simulated disk system. A/D converter analog throttle and variable-speed motor vehicle system DC motor simulation of automotive engines LED display gross vehicle mileage LCD analog current vehicle speed
    2022-02-15 08:46:19下载
    积分:1
  • 超声波传感器智能小车避障程序的研究
    本程序是用GCC编写的超声波传感器智能小车波避障程序,单片机是AVR16-The program of the intelligent car obstacle avoidance by ultrasonic sensor
    2022-03-02 04:56:08下载
    积分:1
  • 客户液晶屏静态扫描驱动,keil
    客户液晶屏静态扫描驱动,keil-51编写。测试通过。-Guest LCD screen static scan driver, keil-51 preparation. Test.
    2022-01-25 16:39:29下载
    积分:1
  • 2410的时钟设置,中断处理。以及USART的调试。
    2410的时钟设置,中断处理。以及USART的调试。-2410 clock settings, interrupt handling. As well as the USART debug.
    2022-02-26 18:05:33下载
    积分:1
  • ts1620 LCD driver 24c02 1302 infrared remote control drive
    ts1620液晶的驱动 24c02 红外遥控器 1302的驱动-ts1620 LCD driver 24c02 1302 infrared remote control drive
    2022-01-27 16:37:11下载
    积分:1
  • 696518资源总数
  • 105877会员总数
  • 14今日下载