-
单片机数据采集与传输给上位机
单片机实现数据采集并传送到上位机-MCU data acquisition and transmission to the PC
- 2023-06-21 05:00:03下载
- 积分：1
-
二相四线制步进电机的驱动程序，时序通过验证可正常运转
二相四线制步进电机的驱动程序，时序通过验证可正常运转-two phase 4-wire stepper motor drivers, timing can be verified through normal operation
- 2023-01-17 11:25:03下载
- 积分：1
-
ARM入门初级基础,主要对ARM 学习有个初步了解和认识,即使没接触过单片机的人也可以轻松学习...
ARM入门初级基础,主要对ARM 学习有个初步了解和认识,即使没接触过单片机的人也可以轻松学习-ARM entry-primary basis, mainly on the ARM to have a preliminary understanding of learning and understanding, even if did not come into contact with SCM can easily learn
- 2022-04-21 11:09:13下载
- 积分：1
-
采用UART方式0与LM74通信。
用C8051f020的P0.7作片选，主机通过TXD发送时钟信号，实现同步通信,半双工.RXD
作双向数据线.用六位
采用UART方式0与LM74通信。
用C8051f020的P0.7作片选，主机通过TXD发送时钟信号，实现同步通信,半双工.RXD
作双向数据线.用六位数码管显示LM74采集的温度值-The use of UART communication mode 0 and LM74. P0.7 used for the C8051F020 chip select, host TXD sent through the clock signal, to achieve synchronous communication, half-duplex. RXD for bi-directional data line. With six digital tube display LM74 temperature collected
- 2022-06-30 14:59:56下载
- 积分：1
-
16C554的应用实例之一，从论文中摘取
16C554的应用实例之一，从论文中摘取-16C554 application of one of removal from the paper
- 2023-07-19 09:05:03下载
- 积分：1
-
51单片机指令集和汇总。解压即可用
51单片机指令集和汇总。解压即可用-51 microcontroller instruction set and summary. Decompression can be used
- 2022-08-18 20:04:53下载
- 积分：1
-
18b20与单片机，与电脑之间串口通信，可以扩展温度计
18b20与单片机，与电脑之间串口通信，可以扩展温度计-18b20 and MCU with serial communication between computers, you can extend the thermometer
- 2022-03-22 21:18:39下载
- 积分：1
-
keilc+ proteus light parallel port design of experiments requirements: master th...
keilc + proteus
并行口设计指示灯实验
要求：掌握80C51单片机输入输出接口使用方法
学会开关量输入输出控制的接口技术及编程方法
实验题目：8个发光二极管D1~D8分别接在单片机P1.0-P1.7端口上，一个开关接在P3.0上。要求输出端口输出 “0”时，发光二极管亮。开关闭合时，开始按P1.0-P1.1-...-P1.7的顺序依次点亮LED，再按 P1.7-P1.6 -...-P1.0的顺序点亮LED，重复循环。开关断开时，立刻停止点亮指示灯。-keilc+ proteus light parallel port design of experiments requirements: master the 80C51 microcontroller input and output interfaces Society of switch to use the amount of input and output control interface technology and programming methods Experimental subjects: eight light-emitting diodes D1 ~ D8, respectively connected to the MCU P1.0-P1 .7 port on a switch connected to the P3.0 on. Requested output port output " 0" , the light-emitting diode light. Is closed, to embark on the P1.0-P1.1-...- P1.7 in the order light LED, and then P1.7-P1.6-...- P1.0 order light LED Repeat cycle. Switch off when the stop light indicator.
- 2022-11-16 18:10:03下载
- 积分：1
-
单片机AT90S系列 制作简易USB接口（软件模拟,无usb硬件）。 programmer
单片机AT90S系列 制作简易USB接口（软件模拟,无usb硬件）。 programmer- Monolithic integrated circuit AT90S series manufacture simple
USB connection (software simulation, non- usb hardware).
Programmer
- 2022-02-01 18:23:15下载
- 积分：1
-
Can communication module of PIC18F458 code
Pic18F458的Can通信模块代码 -Can communication module of PIC18F458 code
- 2023-04-21 06:35:03下载
- 积分：1
