登录
首页 » SCM » 基于ISD4004 的录音系统。该设计通过对ISD4004 语音芯片的介绍,使读者熟悉了1SD4004 的基本应用。同时给出了单片机控制下的硬件电路和软件设计,...

基于ISD4004 的录音系统。该设计通过对ISD4004 语音芯片的介绍,使读者熟悉了1SD4004 的基本应用。同时给出了单片机控制下的硬件电路和软件设计,...

于 2022-12-15 发布 文件大小:77.81 kB
0 176
下载积分: 2 下载次数: 1

代码说明:

基于ISD4004 的录音系统。该设计通过对ISD4004 语音芯片的介绍,使读者熟悉了1SD4004 的基本应用。同时给出了单片机控制下的硬件电路和软件设计,使读者对系统有一个详细的了解。-ISD4004-based recording system. The design through the introduction of the ISD4004 voice chip so that readers familiar with the basic application 1SD4004. At the same time, given under the control of a single-chip hardware circuit and software design, so that readers on the system has a detailed understanding.

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • In a winavr debugging adc procedures, can be tested.
    在winavr上调试的一个adc程序,可测试。-In a winavr debugging adc procedures, can be tested.
    2022-11-17 16:35:03下载
    积分:1
  • avr SCM source code reader 24c512
    avr单片机源码,读写24c512-avr SCM source code reader 24c512
    2023-01-21 06:00:03下载
    积分:1
  • LCD Module Manual Chinese detail to solve the problem of difficult to understand
    液晶显示模块手册中文详细说明,解决英文难懂的问题
    2022-06-17 03:02:46下载
    积分:1
  • 显示界面的显示程序显示 界面的显示程序
    显示界面的显示程序显示 界面的显示程序-Show interface show interface display program to display the show interface display program
    2022-04-21 20:06:46下载
    积分:1
  • 6段数码管分别显示,时,分,秒,四个按键,K1(P0.0),K2(P0.1), K3(P0.2),K4(P0.3),四个按键用来调时间的,按下K1,所有位都...
    6段数码管分别显示,时,分,秒,四个按键,K1(P0.0),K2(P0.1), K3(P0.2),K4(P0.3),四个按键用来调时间的,按下K1,所有位都清零显示,然后按下K2,秒在闪烁,继续按K2分闪烁,不段地按K2 秒--分--时切换着闪烁,在某位闪时按下K3相应位加一,确认调整,按K4,取消调整再按K1。在K1按下以后才有调时的功能,如果K1没有按下,按别的键没有反映。这为了在加点按键功能留着用 -6 respectively of the digital control, when, minutes and seconds, four keys, K1 (P0.0). K2 (P0.1), K3 (P0.2), K4 (width), the four keys to the transfer time, press the K1, All spaces are reset, then press K2, the scintillation seconds, according to K2 pm flickered. not according to K2 of seconds-- minutes-- when switching to flicker in certain press the flash-K3 corresponding increase in a confirmed adjustment by K4, then canceled K1 adjustment. K1 in the press will only be made after the transfer of function, if K1 pressed by other key is not reflected. This points to the function keys used Retention
    2022-08-13 14:18:02下载
    积分:1
  • 基于51的抢答器,谢谢大家!希望大家支持,对大家有用
    基于51的抢答器,谢谢大家!希望大家支持,对大家有用-Answer based on the 51, and I would like to thank everyone! I hope you will support, useful for everyone
    2022-01-22 03:31:08下载
    积分:1
  • The sixth issue of SRTP
    第六期SRTP-基于AT89C52的智能温控仪设计,可以当作课程设计,-The sixth issue of SRTP-based temperature controller AT89C52 intelligent design, can be used as curriculum design,
    2022-02-26 15:19:47下载
    积分:1
  • 这里是51单片机的一些子程序,包括12864LCD的显示,ds18b20的显示,zlg7290的控制。...
    这里是51单片机的一些子程序,包括12864LCD的显示,ds18b20的显示,zlg7290的控制。-Here are some of the subroutines 51 MCU, including the 12864LCD display, ds18b20 display, zlg7290 control.
    2022-11-03 08:00:03下载
    积分:1
  • 89S52作为USB键盘做核心,注意修改厕所…
    使用89S52为核心做的USB键盘,注意修改了一下windows设备描述符以及端点处理等就行了。用了一个4*4的小键盘,有0-9十个数字键, Num Lock键,Caps Lock键,Shift键,Ctrl键,Alt键,回车键等。 最多可以有三个键同时按下,如果相交的话,最多只能两个键按下-89S52 use as the core of the USB keyboard to do, pay attention to modify the look and the windows device descriptor, such as treatment endpoint on the list. Used a 4* 4 small keyboard, has the number keys 0-9 10, Num Lock keys, Caps Lock key, Shift key, Ctrl key, Alt key, enter key and so on. Can have up to three keys pressed at the same time, if the intersection, then a maximum of only two keys pressed
    2023-03-24 10:05:04下载
    积分:1
  • 利用单片机51加sl811芯片实现对u盘读写的控制,代码仅供大家参考,如有不对之处,敬请谅解...
    利用单片机51加sl811芯片实现对u盘读写的控制,代码仅供大家参考,如有不对之处,敬请谅解-Sl811 increase the use of single-chip 51 chip on the u disk read and write control code for your reference, if doing so after updating
    2022-05-17 16:17:27下载
    积分:1
  • 696516资源总数
  • 106642会员总数
  • 12今日下载