-
LT_1B msp430开发板例子程序－UART11_0115k_2
LT_1B msp430开发板例子程序－UART11_0115k_2
- 2023-04-18 04:55:03下载
- 积分：1
-
先进PID控制及其MATLAB仿真（第二版）
先进PID控制及其MATLAB仿真(第二版)-Advanced PID Control and MATLAB Simulation (Second Edition)
- 2022-11-19 12:30:03下载
- 积分：1
-
keilc51 environment compiled through a procedure call can be directly
keilc51 环境下编译通过了的程序,可直接调用-keilc51 environment compiled through a procedure call can be directly
- 2022-12-07 02:40:03下载
- 积分：1
-
clock ic DS1302 the driver. The development environment is under decoder. We hop...
时钟ic DS1302的驱动程序。开发环境是在c51下。希望给大家做个参考。-clock ic DS1302 the driver. The development environment is under decoder. We hope to be a reference. Thank you! !
- 2022-02-24 21:32:54下载
- 积分：1
-
51单片机实现数字时钟带闹钟
使用6个弹跳按钳和4个共阴七段显示器组合而成...
51单片机实现数字时钟带闹钟
使用6个弹跳按钳和4个共阴七段显示器组合而成-51 MCU digital clock with alarm
- 2022-01-25 20:53:14下载
- 积分：1
-
ATmega MCU development of CAN
ATmega单片机开发CAN总线程序，有用！-ATmega MCU development of CAN-bus program, useful!
- 2022-01-25 16:56:02下载
- 积分：1
-
液晶显示程序，初始化、命令字的控制，完整版
液晶显示程序，初始化、命令字的控制，完整版-LCD procedures, initialization, command control characters, the full version
- 2022-06-02 15:13:58下载
- 积分：1
-
Basic knowledge of touch screen Guinness with the latest multi
触摸屏基础知识大全与最新多点触摸屏技术介绍-多点位置识别-Basic knowledge of touch screen Guinness with the latest multi-point touch screen technology introduction- multi-point location identification
- 2022-02-03 14:49:23下载
- 积分：1
-
avr单片机开发EEPROM读写实验源程序
avr单片机开发EEPROM读写实验源程序-Single-chip EEPROM read and write avr developed experimental source
- 2022-03-01 22:32:04下载
- 积分：1
-
MCS
MCS-51单片机有5个中断源，其中两个是由-INT0、-INT1引脚输入的外部中断源；另外三个是内部中断源即由T0、T1的溢出引起中断和串行口发送完一个字节或接收到一个字节数据引起中断。触发外部中断有两种方式，即下降沿引起中断或低电平引起中断。当编程TCON中的ITi（i=0、1）为1时，则引起触发的方式为边沿触发方式，反之(ITi=0)为低电平触发方式。每个中断源的中断请求能否得到响应要受两级“开关”的控制，即一个总“开关”-MCS-51 single-chip has five interrupt sources, two of which are by-INT0,-INT1 pin input external interrupt source the other three internal interrupt sources from the T0, T1 overflow caused by the disruption and serial port sending or receiving end of a byte to a byte of data caused by interruption. Triggered external interrupt has two modes, namely, falling edge or low-level disruption caused disruption caused. When programming TCON in ITi (i = 0,1) for the 1:00 has been the subject of a way to trigger the way to the edge of the trigger, on the contrary (ITi = 0) for low-level trigger mode. Each interrupt source interrupt request can be subject to levels in response to
- 2023-07-06 00:00:03下载
- 积分：1
