登录
首页 » SCM » USART以查询方式收发数据,接收发自电脑的数据,将其显示在LED上,并将接到到的数据减1后返回电脑...

USART以查询方式收发数据,接收发自电脑的数据,将其显示在LED上,并将接到到的数据减1后返回电脑...

于 2023-02-07 发布 文件大小:82.83 kB
0 106
下载积分: 2 下载次数: 2

代码说明:

USART以查询方式收发数据,接收发自电脑的数据,将其显示在LED上,并将接到到的数据减1后返回电脑-USART to send and receive data to query, receive from the bottom of the computer data that could be displayed in the LED, and will receive the data returned by a computer

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 《单片机仿真入门实用教程》实例(包括源代码) 单片机仿真教程。...
    《单片机仿真入门实用教程》实例(包括源代码) 单片机仿真教程。-"PROTEUS Practical Guide Getting Started" examples (including source code) Proteus-based simulation of single-chip microcomputer.
    2022-03-17 13:09:42下载
    积分:1
  • 蜂鸣器响 改变蜂鸣器的频率,通过改变延时时间 蜂鸣器的时间要是是靠延时来完成的...
    蜂鸣器响 改变蜂鸣器的频率,通过改变延时时间 蜂鸣器的时间要是是靠延时来完成的-Buzzer buzzer ring to change the frequency by changing the delay time if the buzzer is the time to be completed by the time delay
    2022-05-30 02:20:29下载
    积分:1
  • 基于AVR的超声波测距程序,使用DS1820测温修正距离
    基于AVR的超声波测距程序,使用DS1820测温修正距离-Ultrasonic Distance Measurement Based on the AVR, the use of the amendment from the DS1820 temperature measurement
    2022-08-22 20:17:31下载
    积分:1
  • === =时钟20:6=== === == 应先初始化状态寄存器 tx1714 EQU 7FFH PA EQU 05H PB EQU 0...
    === =时钟20:6=== === == 应先初始化状态寄存器 tx1714 EQU 7FFH PA EQU 05H PB EQU 06H PC EQU 07H PD EQU 20H IAR EQU 00H 间接寻址寄存器 TMR0 EQU 01H 定时器 STATUS EQU 03H 状态寄存器 BSR EQU 04H bank选择寄存器 PORTA EQU 05H I/0端口寄存器 PORTB EQU 06H I/0端口寄存器 PORTC EQU 07H I/0端口寄存器 PORTD EQU 20H I/0端口寄存器 PULL EQU 21H PULL-High上拉寄存器 WAKEUP EQU 22H 唤醒控制寄存器--被用来设定watchdog允许和禁止 IRQM EQU 23H 中断屏蔽寄存器 IRQF EQU 24H 中断标志寄存器 WDTSEL EQU 25H -=== === = clock 20 : 6 === === === == should first register initialization state tx1714 EQU 7FFH EQU PA PB EQU 05H 06H 07H PC EQU PD EQU 20H IAR E QU 00H indirectly addressable registers TMR0 EQU 01H timer STATUS EQU Mr send state BSR EQU-deposit bank in the 04H choice Register PORTA EQU 05H I/O ports Register P ORTB EQU 06H I/O ports Register PORTC EQU 07H I/O ports Register POR TD EQU 20H I/O ports Register PULL EQU 21H PULL-High pull Register WAKEUP EQU 22H awaken control registers-- were used to set watchdog allowed and prohi
    2022-03-18 22:55:02下载
    积分:1
  • LT_1B msp430开发板例子程序-T2
    LT_1B msp430开发板例子程序-T2
    2022-07-03 21:47:43下载
    积分:1
  • 转速测定,用于测定回转体的转速,测试完成后通过串行接口完成发送,使其它器件显示此信息。...
    转速测定,用于测定回转体的转速,测试完成后通过串行接口完成发送,使其它器件显示此信息。-Speed measured for the determination of rotary speed, the test is completed be completed via the serial interface to send, so that other devices to display this information.
    2022-04-09 05:50:22下载
    积分:1
  • DS18B20 temperature acquisition and display program output, using assembly langu...
    DS18B20温度采集和输出显示程序,用汇编语言实现-DS18B20 temperature acquisition and display program output, using assembly language to achieve
    2022-12-15 18:15:03下载
    积分:1
  • C51KEY
    用C51编[写的按键运用程序,已在产品中运用-C51KEY
    2022-04-11 02:24:31下载
    积分:1
  • 步进电机步距角细分单片机控制系统设计与研究
    步进电机步距角细分单片机控制系统设计与研究-stepper motor breakdown step angle SCM Control System Design and Research
    2022-08-23 19:42:43下载
    积分:1
  • Using 8
    采用8位LED动态扫描时钟演示程序,使用12MHZ晶振,P0口输出段码,P2口作列扫描,用共阳LED数码管。-Using 8-bit dynamic scanning LED clock demonstration, the use of 12MHZ crystal, P0 port output above code, P2 scan I made out with a total of LED digital tube Yang.
    2022-09-13 02:30:06下载
    积分:1
  • 696516资源总数
  • 106642会员总数
  • 12今日下载