-
自己编写的一个单片机控制红外发送与接收的红外接收源程序,同时自己也做了一个板实验,是成功的哦...
自己编写的一个单片机控制红外发送与接收的红外接收源程序,同时自己也做了一个板实验,是成功的哦-I have written a single chip to send and receive infrared control infrared receiver of the source, at the same time also made a plate experiment was a success, oh
- 2022-08-17 04:44:57下载
- 积分：1
-
基于CAN总线的电梯控制系统，包括主板程序，子板程序和电路原理图...
基于CAN总线的电梯控制系统，包括主板程序，子板程序和电路原理图-Based on CAN Bus elevator control system, including the board procedures, sub-board procedures and circuit diagram
- 2023-01-17 10:15:04下载
- 积分：1
-
51单片机八位数码管显示初阶C程序，位选用的138译码器连接，压缩包里面有原理图...
51单片机八位数码管显示初阶C程序，位选用的138译码器连接，压缩包里面有原理图-51 MCU 8 digital tube display elementary C program, optional 138-bit decoder connected, compressed packets inside diagram
- 2023-08-16 15:25:02下载
- 积分：1
-
串口转发IIC程序，用MEGA16实现，调试IIC接口时非常有用。
串口转发IIC程序，用MEGA16实现，调试IIC接口时非常有用。-IIC serial transponder procedures used MEGA16 realized, IIC debugging interface will be very useful.
- 2022-02-21 15:13:08下载
- 积分：1
-
C51单片机汉字机内码 C51单片机汉字机内码
C51单片机汉字机内码 C51单片机汉字机内码-C51 microcontroller Chinese machine code C 51 microcontroller Chinese machine code
- 2022-07-26 16:35:39下载
- 积分：1
-
使用MSP430和CS8900开发Web服务器，可以看到动态温度。
使用MSP430和CS8900开发Web服务器，可以看到单片机的动态温度。
- 2022-08-30 16:43:46下载
- 积分：1
-
用STC89C51RC单片机控制的I2C总线高频头程序
用STC89C51RC单片机控制的I2C总线高频头程序-STC89C51RC MCU with I2C Bus tuner program
- 2022-01-27 09:08:26下载
- 积分：1
-
硬件电路液晶显示模块1602引脚程序。初学者必备
硬件电路液晶显示模块1602引脚程序。初学者必备-Hardware circuit pin LCD module process 1602. Beginners must
- 2022-04-10 02:17:31下载
- 积分：1
-
With the program AD9854C.exe one can set and tune the frequency in CW
With the program AD9854C.exe one can set and tune the frequency in CW-mode. For use as a receiver LO also IF can be given and the both possible receiving frequencies are printed on the screen. The level in Q-outputs can be varied by giving the wanted attenuation in dB. This function is done by controlling a 12b digital multiplier in the device. In this case the level decreases somewhat with increasing frequency as it does in DDS devices. Alternatively the inverse sinc correction can be chosen, in which case the output is flat and high. -With the program AD9854C.exe one can set and tune the frequency in CW-mode. For use as a receiver LO also IF can be given and the both possible receiving frequencies are printed on the screen. The level in Q-outputs can be varied by giving the wanted attenuation in dB. This function is done by controlling a 12b digital multiplier in the device. In this case the level decreases somewhat with increasing frequency as it does in DDS devices. Alternatively t
- 2022-08-02 19:18:16下载
- 积分：1
-
基于51的单片机的PPP协议实现，源代码
基于51的单片机的PPP协议实现，源代码-51 Based on the SCM PPP protocol, the source code
- 2022-07-18 22:44:15下载
- 积分：1
