登录
首页 » SCM » flash m25p80的读写程序,使用软件模拟SPI总线进行操作。

flash m25p80的读写程序,使用软件模拟SPI总线进行操作。

于 2023-04-10 发布 文件大小:2.95 kB
0 40
下载积分: 2 下载次数: 1

代码说明:

flash m25p80的读写程序,使用软件模拟SPI总线进行操作。-flash m25p80 of reading and writing, the use of software simulation of SPI bus operations.

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • with Parallel Communications, only this simulation software hexadecimal display...
    用并口通信时,只需发送仿真软件的十六进制显示窗口的第四个字节后的所有数据。 如:清全屏的十六进制显示窗口是55AA0001434C42,采用并口通信时只需发送434C42-with Parallel Communications, only this simulation software hexadecimal display window of words, after the data. Such as : a full-hexadecimal 55AA0001434C42 show window is used and only parallel communication sent 434C42
    2022-03-21 15:04:56下载
    积分:1
  • AD9850的资料,里面有源码,可以提供一个美国模式。
    AD9850资料,内有源程序代码,可以给大家提供一个模本。-AD9850 data, which has source code, can provide a mode of the U.S..
    2022-07-19 06:59:07下载
    积分:1
  • Detailed RF test source of non
    详细的RF非接触卡测试源码,详细的备注。-Detailed RF test source of non-contact cards, detailed Remarks.
    2022-09-05 05:50:02下载
    积分:1
  • 采用UART方式0与LM74通信。 用C8051f020的P0.7作片选,主机通过TXD发送时钟信号,实现同步通信,半双工.RXD 作双向数据线.用六位
    采用UART方式0与LM74通信。 用C8051f020的P0.7作片选,主机通过TXD发送时钟信号,实现同步通信,半双工.RXD 作双向数据线.用六位数码管显示LM74采集的温度值-The use of UART communication mode 0 and LM74. P0.7 used for the C8051F020 chip select, host TXD sent through the clock signal, to achieve synchronous communication, half-duplex. RXD for bi-directional data line. With six digital tube display LM74 temperature collected
    2022-06-30 14:59:56下载
    积分:1
  • hd44780 driver used in MCU development
    hd44780驱动程序 单片机开发中用到的-hd44780 driver used in MCU development
    2022-04-21 03:35:35下载
    积分:1
  • 自己写的C51仿真器代码
    自己写的C51仿真器代码-himself wrote the code C51 Emulator
    2022-02-27 07:57:48下载
    积分:1
  • This procedure for the use of mage8 AVR and achieve EM4094 read TYPE A type of c...
    此程序为利用mage8 AVR 和EM4094实现读取TYPE A类型卡的C程序、读卡稳定、这个项目我们做了好久、非常不错的程序、很适合做这方面产品的朋友们参考-This procedure for the use of mage8 AVR and achieve EM4094 read TYPE A type of card C procedures, reader stability, the project we have done for a long time, very good program, it is suitable for products in this area refer to my friends
    2022-07-04 04:43:37下载
    积分:1
  • f020 PCA产生16位或者16 位的PWM 波形
    f020 PCA产生16位或者16 位的PWM 波形-f020 PCA produced 16 or 16 of the PWM waveform
    2023-08-28 21:55:03下载
    积分:1
  • 74ls165控制扫描键盘,串行输出键值的c51键盘程序,并在led上显示...
    74ls165控制扫描键盘,串行输出键值的c51键盘程序,并在led上显示-74ls165 control scanning keyboard, serial output of the decoder keyboard keys procedures, and led the show
    2022-01-21 17:56:39下载
    积分:1
  • 急救车与交通灯)(1)南北与东西方向,每个方面由红黄绿三个灯控制(2)南北向: 红(30秒),黄(5秒),绿(25秒)   东西向: 红(35秒),黄(5秒),...
    急救车与交通灯)(1)南北与东西方向,每个方面由红黄绿三个灯控制(2)南北向: 红(30秒),黄(5秒),绿(25秒)   东西向: 红(35秒),黄(5秒),绿(25秒)   上述基本参数可以根据实际情况自行调整,灯的变化规律与实际路口规律相同,绿灯在最后5秒钟时,黄灯亮,然后红灯亮,不允许两个方面同时亮绿灯。(3)绿灯的时间显示在数码管上进行显示。(4)可以通过一个开关控制,当开关信号为0时,整个交通灯全灭提高要求:(1)设计一个紧急控制开关信号,当紧急开关信号为1时,两个方向的灯全为红灯。紧急开关撤消后,按照开关按下之前的状态继续运行(其参数要保存)。(2)设计一个夜间行车开关,当开关按下后,两个方向都只有黄灯闪烁,其它灯熄灭。(3)设计两个方向的亮时时间可调。-emergency vehicles and traffic lights) (1) North and South and east-west direction, each with three yellow-green from red lights control (2) to the north and south : red (30 seconds), yellow (5 seconds), Green (25 seconds) to things : red (35 seconds), yellow (5 seconds) Green (25 seconds) above basic parameters can be adjusted to the actual situation, the light changes with the actual law of the same intersection, the green light in the final five seconds, the yellow light is on, and then a red light, bright, not two fronts simultaneously bright green. (3) the green light at the time displayed on the digital display control. (4) can be controlled by a
    2022-01-22 01:28:42下载
    积分:1
  • 696522资源总数
  • 104027会员总数
  • 45今日下载