-
中国电信 东北9省
客服系统E_R设计
中国电信 东北9省
客服系统E_R设计-northeast China Telecom nine provinces customer service system design E_R
- 2022-03-12 03:37:52下载
- 积分：1
-
This article: FPGA method used to simulate the high dynamic (Global Position Sys...
本文：采用了FPGA方法来模拟高动态(Global Position System GPS)信号源中的C／A码产生器。C／A码在GPS中实现分址、卫星信号粗捕和精码(P码)引导捕获起着重要的作用，通过硬件描述语言VERILOG在ISE中实现电路生成，采用MODELSIM、SYNPLIFY工具分别进行仿真和综合。-This article: FPGA method used to simulate the high dynamic (Global Position System GPS) signal source of the C/A code generator. C/A code in GPS to achieve sub-sites, the satellite signal capture coarse and fine code (P code) lead capture plays an important role, through hardware description language Verilog in ISE to achieve circuit to generate, using MODELSIM, SYNPLIFY simulation tools were and integrated.
- 2022-02-05 10:44:00下载
- 积分：1
-
几篇应用于雷达设计的Kalman滤波相关论文
几篇应用于雷达设计的Kalman滤波相关论文-Applies to the design of several radar Kalman filter papers
- 2022-11-28 17:00:04下载
- 积分：1
-
运放选型
运算放大器的结构形式主要有三种：模块、混合电路和单片集成电路。对于设计工程师来说，不仅是要知道所用产品的型号，而且还应熟悉生产这些产品的工艺，...
运放选型
运算放大器的结构形式主要有三种：模块、混合电路和单片集成电路。对于设计工程师来说，不仅是要知道所用产品的型号，而且还应熟悉生产这些产品的工艺，从而能够从一类放大器中选出一种放大器做特定的应用。-Selection of operational amplifier OPAMP structure There are three main types: modules, hybrid circuits and monolithic integrated circuit. Design Engineer for example, not only to know the product you are using models, but also familiar with the production process of these products in order to be able to elect one Class A amplifier amplifier make specific applications.
- 2022-01-27 20:30:05下载
- 积分：1
-
s3c6410的pcb板图，pdf格式，作为布线参考用
s3c6410的pcb板图，pdf格式，作为布线参考用-s3c6410 map of pcb board, pdf format, as a reference wiring
- 2023-08-25 02:55:04下载
- 积分：1
-
Guide the introduction of some of the operating system on the learning guide are...
操作系统引导的一些介绍,对学习引导的有很大的帮助与提高-Guide the introduction of some of the operating system on the learning guide are of great help and improve
- 2022-01-22 05:00:04下载
- 积分：1
-
这是我从网看到的，不用电平的转换IC就可以把串口TTL输入、输出的电平转换成计算机能识别的电平，原图经测试不能用，经我改进后效果很好，大家不妨一试...
这是我从网看到的，不用电平的转换IC就可以把串口TTL输入、输出的电平转换成计算机能识别的电平，原图经测试不能用，经我改进后效果很好，大家不妨一试-This is what I see from the network, not power conversion IC level can be the serial TTL input and output level into the computer to identify the level, the maximum should not have been tested, and improved by my very good , we may as well try
- 2022-07-27 17:16:13下载
- 积分：1
-
如何发现和解决FPGA设计偏移时序约束问题
如何发现并解决FPGA设计中的时序问题OFFSET约束-How to find and solve the FPGA design OFFSET timing constraint problem
- 2022-03-21 14:20:32下载
- 积分：1
-
Database System Design Course
数据库系统课程设计-Database System Design Course
- 2022-03-24 02:10:39下载
- 积分：1
-
FPGA的设计流程以及DSP设计,FPGA培训核心讲义，对开发FPGA的高级人员和初级人员都非常有用...
FPGA的设计流程以及DSP设计,FPGA培训核心讲义，对开发FPGA的高级人员和初级人员都非常有用-FPGA design
- 2023-02-25 08:00:03下载
- 积分：1
