登录
首页 » SCM » 用89S51做的红外编码解码程序。载波用555做

用89S51做的红外编码解码程序。载波用555做

于 2023-04-25 发布 文件大小:2.12 kB
0 27
下载积分: 2 下载次数: 1

代码说明:

用89S51做的红外编码解码程序。载波用555做-89S51 do with the infrared codec procedures. Carrier to do with 555

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • STCS89C51单片机的介绍,给热爱STCS89C51的朋友提供一个参考资料。...
    STCS89C51单片机的介绍,给热爱STCS89C51的朋友提供一个参考资料。-SCM STCS89C51 introduction to the love of friends STCS89C51 to provide a reference.
    2022-05-14 14:27:12下载
    积分:1
  • MPX4105 figures based on the barometer, using single
    基于MPX4105的数字气压计,用单片机控制,希望大家喜欢!-MPX4105 figures based on the barometer, using single-chip control, I hope everyone likes!
    2022-11-21 06:05:03下载
    积分:1
  • 61505LCD的单片机驱动程序,此程序已在KEIL上调试成功
    61505LCD的单片机驱动程序,此程序已在KEIL上调试成功-61505LCD microcontroller drivers, this procedure has been successful in KEIL debug
    2022-02-01 11:31:10下载
    积分:1
  • This is the time to participate in Electronic Design Contest works: infrared rem...
    这是参加电子设计大赛时的作品:红外遥控小车:用红外线通过一块AT89S52单片机发射信号即编码,并用红外接收头接收信号;接着再用另一块AT89S52单片机对红外发射出的信号编码进行解码,最后再用一块AT89S52单片机用解码所得码值编写程序后驱动步进电机。步进机功能启动后不仅能使受控小车向前后左右四个方向前进和转弯,而且还能控制小车再地上转动并留下方形或圆形等形状。-This is the time to participate in Electronic Design Contest works: infrared remote control car: Using infrared transmission signal through an AT89S52 microcontroller that is encoded and used infrared receiver to receive the first signal and then using the other an infrared emitting MCU AT89S52 code and decode the signal and finally an AT89S52 microcontroller then proceeds with the decoding key value of the preparation of procedures to drive a stepper motor. Stepper machine function activated not only make the car forward in a controlled direction and after about four turns, but also to control the car and then turned and left the ground such as square or round shapes.
    2022-05-06 18:46:07下载
    积分:1
  • ic卡读写方式和内容,程序的模块化可用,比较方便,还可以
    ic卡读写方式和内容,程序的模块化可用,比较方便,还可以-IC card reader formats and contents, procedures can be modular, more convenient, but also
    2022-02-02 23:50:39下载
    积分:1
  • CYGNAL单片机,C8051FXXX应用例程6
    CYGNAL单片机,C8051FXXX应用例程6-CYGNAL microcontroller, C8051FXXX routines 6
    2022-01-26 03:35:52下载
    积分:1
  • 智能车仿真程序++仿真 在protel环境下单片机
    智能车仿真程序++仿真 在protel环境下单片机-smartcar simulation program++ simulation
    2023-08-03 16:10:03下载
    积分:1
  • 本程序是一个WGM
    本程序是一个WGM-12864LCD的驱动程序。不带字库。用了一晚上的时间终于调出来了。能显示汉字图片。给大家共享享。-This procedure is a WGM-12864LCD drivers. Without the font. Spent one night finally tune out. Can display Chinese characters picture. To the U.S. share entitlements.
    2022-01-28 12:00:41下载
    积分:1
  • 我用单片机8952和电压比较器339做了一个简单的电容容量测量表,参数大 致如下: 电容测量范围为1pF...
    我用单片机8952和电压比较器339做了一个简单的电容容量测量表,参数大 致如下: 电容测量范围为1pF-9999.99uF,最小分辨力为1pF。分为5个量程,可以自 动切换量程,也可手动切换。 另外,有简单的频率计功能,能测量0-60MHz的数字信号频率(TTL电平); 还可以产生几个单点频率的方波信号(比如1KHz)。 采用1602LCD作为显示器;4个按键控制;使用24C01保存当前设置值,不用 每次开机重新设置。可单5V供电,也可9V交流供电 -I used the single-chip 8952 and the voltage comparator 339 to do a simple capacitance measurement table, parameters are as follows: capacitance measurement range 1pF-9999.99uF, the minimum resolution for the 1pF. Divided into five ranges, you can automatically switch range can also be manually switched. In addition, a simple frequency meter function, capable of measuring 0-60MHz frequency digital signal (TTL level) can also lead to several single-point-frequency square-wave signal (for example, 1KHz). 1602LCD used as a monitor 4 button control use 24C01 to preserve the current settings, do not reset each boot. Can be a single 5V power supply, 9V AC power supply can also be
    2023-08-10 15:10:03下载
    积分:1
  • 阵列ccd511驱动,微处理器的使用
    线阵CCD511的驱动,使用C8051F020单片机进行驱动-array CCD511 driving, the use of microprocessor-driven C8051F020
    2022-10-06 16:55:02下载
    积分:1
  • 696522资源总数
  • 104045会员总数
  • 50今日下载