登录
首页 » 嵌入式系统 » 手写识别芯片EPH1100的驱动源码,基于Linux平台.

手写识别芯片EPH1100的驱动源码,基于Linux平台.

于 2023-05-12 发布 文件大小:6.27 kB
0 51
下载积分: 2 下载次数: 1

代码说明:

手写识别芯片EPH1100的驱动源码,基于Linux平台.-handwriting recognition chip EPH1100 driver source code, based on the Linux platform.

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • The TMS302VC54x to TI digital signal processor (DSP) for embedded controllers, E...
    以TI的TMS302VC54x数字信号处理器(DSP)为嵌入式控制器、ERICSSON的蓝牙模块为例,在蓝牙电缆替代协议应用模块的基础上,提出一种将电缆替代协议进行扩展的嵌入式蓝牙应用模式及其硬、软件的实现-The TMS302VC54x to TI digital signal processor (DSP) for embedded controllers, ERICSSON Bluetooth module, for example, in the Bluetooth cable replacement application modules based on the agreement is presented to extend the cable replacement protocol embedded Bluetooth application mode Its hardware and software implementation
    2022-01-26 01:21:16下载
    积分:1
  • 本程序能够在没有操作下可以测试LCD的驱动,在LINUX下和WINCE下都可以根据这段程序里面的寄存器设置进行驱动程序的编写!...
    本程序能够在没有操作系统下可以测试LCD的驱动,在LINUX下和WINCE下都可以根据这段程序里面的寄存器设置进行驱动程序的编写!-This procedure can in the absence of operating system you can test LCD driver in under LINUX and WINCE under this procedure can be the basis of the register inside the driver settings to prepare!
    2022-09-20 12:40:03下载
    积分:1
  • study arm step by step,本文从学习者的角度出发,分别描述了下面几部分内容: ARM 编程的基本知识,BOOT代码流程和功能分析,O...
    study arm step by step,本文从学习者的角度出发,分别描述了下面几部分内容: ARM 编程的基本知识,BOOT代码流程和功能分析,OS 中断程序的编写举例 和BOOT代码的流程图,希望这些内容能为初学ARM的朋友拨开迷雾,以最快 的速度和最短的时间走进嵌入世界的大们-study arm step by step, this article from the learner" s point of view, respectively, describe the contents of the following sections: ARM basic knowledge of programming, BOOT code processes and functional analysis, OS interrupt the preparation process and the BOOT code, for example, flow charts, hope that these content for beginners ARM" s friends fog, with the fastest speed and the shortest possible time into the world" s largest embedded in their
    2023-06-15 05:25:12下载
    积分:1
  • led, key, i2c, uart, adc, rtc, wdt measured SHI document code
    led,key,i2c,uart,adc,rtc,wdt测SHI 文件代码-led, key, i2c, uart, adc, rtc, wdt measured SHI document code
    2022-03-14 00:01:20下载
    积分:1
  • M32C 完整项目
    完整的项目基于 Rs232C M32C Basato su un applicazione che dialoga in Rs232C con un server per comandare una scheda remota di i/o per gestire un tester di cablaggi 
    2023-04-22 06:45:03下载
    积分:1
  • 这是本人开发板上的关于uclinux开发的文章,介绍的很详细,很适合门...
    这是本人开发板上的关于uclinux开发的文章,介绍的很详细,很适合入门-this is my development board on the Basis of Development article, we introduce the very detailed, it is very suitable for induction
    2023-06-02 00:45:03下载
    积分:1
  • 红外遥控器已被广泛使用在各种类型的家电产品上,它的出现给使用家器提供了很多的便利。红外遥控一般由红外发射装置和红外接受设备两大部分组成。红外发射装置又可由键...
    红外遥控器已被广泛使用在各种类型的家电产品上,它的出现给使用家器提供了很多的便利。红外遥控系统一般由红外发射装置和红外接受设备两大部分组成。红外发射装置又可由键盘电路、红外编码芯片、电源和红外发射电路组成。红外接收设备可由红外接收电路、红外解码芯片、电源和应用电路组成。通常为了使信号能更好的被传输发送端将基带二进制信号调制为脉冲串信号,通过红外发射管发射。本设计采用Atmega8作为红外发射编码和接收解码芯片。-Infrared remote control has been widely used in various types of household electrical appliances, it" s there to provide the users a lot of convenience. Infrared remote control system in general by the infrared emission devices and infrared devices to accept the composition of two major parts. Infrared emission circuit device can be by keyboard, infrared encoder chip, power and infrared emission circuit. By the infrared receiver infrared receiver circuit equipment, infrared decoder chip, power supply and application circuit. Usually better in order to signal the sending end of the transmission to binary base-band signal for pulse modulation, through the launch tube infrared emission. The design uses infrared emission Atmega8 as encoding and decoding chip receiver.
    2022-05-06 14:11:23下载
    积分:1
  • 双串口通信源代码
    双串口通信源代码--Source code for 2 serial ports communication.
    2022-02-05 03:53:48下载
    积分:1
  • MCUProductionProgrammer_Silicon
    MCUProductionProgrammer  Silicon Lab In-system programming  involves programming devices after installation inthe end system. In this scenario, access to the debug pins (JTAG or C2 interface) is provided in the end system to enable connection to a programming “Master”. This pro-gramming “Master” can bea Silicon Labs Serial Adapter (EC2), custom hardware, or for JTAG devices, a JTAG Boundary Scan test system that supports the programming ofSilicon Labs devices.
    2022-08-05 18:50:27下载
    积分:1
  • 大学自动报警
    手动操作的上课铃学院钟产生了大量的人为错误造成的滋扰。如果钟操作员忘记特定期间,铃或延迟时按铃,它可以创建扰动的整个制度。在那一天的所有类都将都被完全打扰。这个问题是更存在如果贝尔运算符是在休假。自动定期学院钟是唯一的解决办法,避免所有这些问题。 在学校、 学院和教育 / 学术机构的定期下课铃自动化,这个项目是非常有用的。此铃声仅在预先排练时间。作为 DS1307 实时时钟芯片后,整个日历可以被编程到微控制器。用户可以编程的钟声响了门铃,从早上到晚上而不是环放学后和在星期日和第二个星期六。 交换机提供用于输入所需的排练时间。七段显示提供要显示的报警时间和当前时间。DS1307 被连接到单片机为真正的计时性能。3V 电池可以连接到 DS1307,避免时间扰动引起的电源故障。 外部 eprom 芯片用来存储数据。存储的数据保留在内存中甚至停电后,因为内存确保阅读由微控制器的最新的已保存设置。它可以将数据保留超过十年。 此项目使用 5V,500mA 电源。不受管制的
    2022-03-01 12:40:30下载
    积分:1
  • 696524资源总数
  • 103827会员总数
  • 23今日下载