登录
首页 » SCM » flashflex51单片机

flashflex51单片机

于 2023-05-19 发布 文件大小:68.18 kB
0 171
下载积分: 2 下载次数: 1

代码说明:

FlashFlex51微控制器

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • in our company do C51 microcontroller refueling procedures
    这是我在我们公司做的C51加油单片机程序-in our company do C51 microcontroller refueling procedures
    2022-03-26 08:51:43下载
    积分:1
  • 伟福 WAVE6000 环境下MCS51 C51调用汇编例程
    伟福 WAVE6000 环境下MCS51 C51调用汇编例程-Wei Fu WAVE6000 environment MCS51 C51 compilation called routine
    2022-02-06 17:23:06下载
    积分:1
  • 12864液晶在出厂时其对比度已经调好,所以用户在使用的时候第三管脚可不用接任何东西,本实验板上为了兼容多家12864液晶所以加了液晶对比度调节电位器,若用户使...
    12864液晶在出厂时其对比度已经调好,所以用户在使用的时候第三管脚可不用接任何东西,本实验板上为了兼容多家12864液晶所以加了液晶对比度调节电位器,若用户使用我们配套的12864液晶可不用管它,液晶的第三管脚悬空就可以。有些液晶功耗比较大,用户在使用的时候可将液晶的第19、20引脚的背光不接,这样字体会很清楚-12864 LCD contrast, when the factory has a good tune, so when users can not access the third pin anything, this experiment in order to compatible with more than 12,864 on-board LCD so the addition of LCD contrast adjustment potentiometer, if users supporting our 12864 can not regardless of LCD, LCD" s third pin can be left vacant. Some relatively large power consumption of LCD, users can be used when the first 19,20 LCD backlight will not receive the pin, so that fonts will be very clear
    2023-06-25 07:55:03下载
    积分:1
  • FIQ有FIQ_PWM、FIQ_TMA和FIQ_TMB三个中断源,当定时器A或B计满溢出时产生中断请求信号TA_TIMEOUT_INT或TA_TIMEOUT_I...
    FIQ有FIQ_PWM、FIQ_TMA和FIQ_TMB三个中断源,当定时器A或B计满溢出时产生中断请求信号TA_TIMEOUT_INT或TA_TIMEOUT_INT,CPU响应后进入中断执行相应的子程序控制二极管发光。A口的低四位接LED灯,B口的低四位接LED灯.-FIQ has FIQ_PWM, FIQ_TMA and FIQ_TMB three interrupt sources, when the timer A or B when the expiration overflow interrupt request signal TA_TIMEOUT_INT or TA_TIMEOUT_INT, CPU response after interruption of the implementation of the corresponding subprogram control light-emitting diodes. A low population of four LED lights then, B I take the low four LED lights.
    2022-02-03 11:57:06下载
    积分:1
  • Content:* IR test program, launched with the microcontroller through the launch...
    内容: *红外测试程序,用单片机通过发射管发射38K的调制频率码,由一体化接收并解码由发光管显示。 *正常情况下,由于反射和高灵敏度接收,LED4(P1.3)一直闪烁,可以用黑色纸片完全遮挡接收头使 *之不能接收到发射管的信号,这是LED4熄灭。说明功能性正常 -Content:* IR test program, launched with the microcontroller through the launch tube of the modulation frequency of 38K code, by the integration to receive and decode from the LED display.* Under normal circumstances, due to reflection and high-sensitivity receiver, LED4 (P1.3) has been flickering, you can completely block the black pieces of paper to make* that they are not receiving the first emission control signal is received, it is LED4 out. Note the normal functional
    2022-03-20 16:16:04下载
    积分:1
  • Single
    单片机控制火车车厢门上方的LED显示程序-Single-chip microcomputer to control the top of the train compartment door LED display program
    2023-01-26 10:30:04下载
    积分:1
  • 用C51编的温度控制的PID算法适用性强方便移植
    用C51编的温度控制的PID算法适用性强方便移植-with C51 series of PID temperature control algorithm to facilitate transplantation 3DMECAD
    2023-02-09 06:00:03下载
    积分:1
  • 4* 4 key scan control LED display
    4*4按键扫描控制数码管显示 通过不同按键控制数码管的显示-4* 4 key scan control LED display
    2022-03-20 06:34:55下载
    积分:1
  • 利用8051驱动GPS模块,实现GPS定位功能。
    利用8051驱动GPS模块,实现GPS定位功能。-8051 drivers use GPS modules, GPS positioning function realize.
    2022-10-03 13:15:04下载
    积分:1
  • CC2500 with MSP430F2274 the send and receive routines
    CC2500与MSP430F2274的发送与接收例程-CC2500 with MSP430F2274 the send and receive routines
    2022-01-25 15:56:06下载
    积分:1
  • 696516资源总数
  • 106446会员总数
  • 9今日下载