登录
首页 » 文档处理 » mp3DIY调试所需固件程序 可以让初学者好好参考

mp3DIY调试所需固件程序 可以让初学者好好参考

于 2023-05-21 发布 文件大小:55.96 kB
0 144
下载积分: 2 下载次数: 1

代码说明:

mp3DIY调试所需固件程序 可以让初学者好好参考-mp3DIY debug firmware needed to allow a good reference for beginners

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 多线程管发现数据库死锁问题
    多线程管理发现处理数据库死锁问题-Found to deal with the management of multi-threaded database deadlock
    2022-02-13 10:21:51下载
    积分:1
  • 校友录
    校友录-Classmates record of the same school.
    2022-08-06 02:32:38下载
    积分:1
  • converged network simulation technology that one
    聚合网络技术模拟题1-converged network simulation technology that one
    2022-02-05 18:45:15下载
    积分:1
  • 信号导论
    Introduction to signal processing
    2023-07-26 03:55:03下载
    积分:1
  • S7600 TCP_IP网络协议接口芯片资料
    S7600 TCP_IP网络协议接口芯片资料-S7600 TCP_IP network protocol data interface chip
    2022-12-18 00:40:03下载
    积分:1
  • 移动自组网的分布式对称密钥管
    Distributed Symmetric Key Management for Mobile Ad hoc Networks
    2022-09-22 01:00:03下载
    积分:1
  • c语言编程中关于层次代码优化
    c语言编程中关于层次代码优化-on the level of code optimization
    2022-01-25 16:13:31下载
    积分:1
  • transplantation using ADS UC/OS
    使用 ADS 移植UC/OS-II的实例分析-transplantation using ADS UC/OS-II Case Analysis
    2022-02-28 12:06:04下载
    积分:1
  • 44b0 buzzer experiment. Rar
    44b0蜂鸣器实验.rar-44b0 buzzer experiment. Rar
    2023-08-03 19:10:03下载
    积分:1
  • In the STAR ES598PCI veneer development machine to realize oven temperature and...
    ① 设计并开发能检测温室温度信号,并能产生报警信号的系统; ② 通过在程序中设置温度界限值,能判断采集的温度是否超过界限值; ③ 若温度值越界则进行声(蜂鸣器)、光(发光二极管)报警; 说明:界限值是自行设定的(26C),其所对应的数字量为十六进制数(0180H)。 (2)使用DS18B20采集温度,采用七段数码管显示当前温度和剩余时间,并和设置的温度进行比较。 (3)当温度低于设定值时,通过DAC0832输出电压供给发热电阻RT1,使其温度升高。 (4)使温度恒定在设定温度附近,时间到了停止加热,并提示操作完毕。 -In the STAR ES598PCI veneer development machine to realize oven temperature and time control functions. Design requirements: (1) through the keyboard to set the temperature and heating time. (2) The use of DS18B20 collecting temperature, using seven-segment digital tube displays the current temperature and the remaining time, and and set the temperature for comparison. (3) When the temperature is below the set value, the DAC0832 output voltage of the supply of heat through the resistor RT1, so that temperature. (4) to enable the temperature constant at the set temperature near the time to the cessation of heating, and prompt action is completed.
    2022-07-27 01:54:00下载
    积分:1
  • 696518资源总数
  • 105873会员总数
  • 12今日下载