登录
首页 » SCM » 详细介绍 智能仪器的基本数据处理算法 适合系统学习的人员 仅供参考...

详细介绍 智能仪器的基本数据处理算法 适合系统学习的人员 仅供参考...

于 2023-05-26 发布 文件大小:58.18 kB
0 42
下载积分: 2 下载次数: 1

代码说明:

详细介绍 智能仪器的基本数据处理算法 适合系统学习的人员 仅供参考-The basic details of intelligent instruments systematic study of data-processing algorithm is suitable for staff reference

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 单片机 时钟程序,包含秒表,闹钟,时间三个功能
    单片机 时钟程序,包含秒表,闹钟,时间三个功能-MCU clock.c
    2022-02-02 09:34:14下载
    积分:1
  • 单片机开发必备,8*16,12*16,16*16汉字点阵生成程序,适用于DOS环境...
    单片机开发必备,8*16,12*16,16*16汉字点阵生成程序,适用于DOS环境-MCU Development essential, 8 16,12*** 16 Bloemycin Chinese lattice formation procedures, apply to the DOS environment
    2023-03-27 13:55:03下载
    积分:1
  • 飞思卡尔单片机MC9S08AW60移植到MC9S08AC60方法(英文)
    飞思卡尔单片机MC9S08AW60移植到MC9S08AC60方法(英文)-Freescale
    2022-12-16 20:35:04下载
    积分:1
  • MCS51 LCD controller and interface applications, the FX
    LCD控制器与MCS51接口的应用, FX-TXXXXC256A系列LCD控制器支持256色的TFT, 分辨率支持320*240(234), 400*240(234), 480*240(234), 640*480, 800*600等-MCS51 LCD controller and interface applications, the FX-series TXXXXC256A LCD controller supports 256-color TFT, resolution 320* 240 (234) 400* 240 (234) 480* 240 (234) 640* 480 and 800* 600 etc.
    2022-03-21 09:15:02下载
    积分:1
  • 简单的程序,使用红外线发射的低
    简易红外线发射程序 使用低频率的发射 利用红外线二极管来做-simple procedure using infrared emission of low-frequency transmitters do using infrared diode
    2023-06-27 03:15:04下载
    积分:1
  • nRF24LO1_SPI procedures, MCU control nRF24LO1 between the two wireless communica...
    nRF24LO1_SPI程序,MCU控制两块nRF24LO1之间的无线通讯,也可以通过UART打印和发送数据-nRF24LO1_SPI procedures, MCU control nRF24LO1 between the two wireless communications, can also print and send data UART
    2023-01-24 11:30:03下载
    积分:1
  • This is the time to participate in Electronic Design Contest works: infrared rem...
    这是参加电子设计大赛时的作品:红外遥控小车:用红外线通过一块AT89S52单片机发射信号即编码,并用红外接收头接收信号;接着再用另一块AT89S52单片机对红外发射出的信号编码进行解码,最后再用一块AT89S52单片机用解码所得码值编写程序后驱动步进电机。步进机功能启动后不仅能使受控小车向前后左右四个方向前进和转弯,而且还能控制小车再地上转动并留下方形或圆形等形状。-This is the time to participate in Electronic Design Contest works: infrared remote control car: Using infrared transmission signal through an AT89S52 microcontroller that is encoded and used infrared receiver to receive the first signal and then using the other an infrared emitting MCU AT89S52 code and decode the signal and finally an AT89S52 microcontroller then proceeds with the decoding key value of the preparation of procedures to drive a stepper motor. Stepper machine function activated not only make the car forward in a controlled direction and after about four turns, but also to control the car and then turned and left the ground such as square or round shapes.
    2022-05-06 18:46:07下载
    积分:1
  • the original source applications in cpu (st89le516AD), GPRS module sim100 contro...
    该原代码应用在cpu(st89le516AD+)上,控制GPRS模块sim100,通过检测系统状态(通电状态,运行状态,AD采样值),通过GPRS模块的短信功能,实现无线报警.-the original source applications in cpu (st89le516AD), GPRS module sim100 control through detection system state (state electricity, running AD values), GPRS module messaging functions, wireless alarm.
    2022-08-31 20:15:03下载
    积分:1
  • 利用c8051 的adc 做按键控制led
    利用c8051 的adc 做按键控制led-C8051 make use of the adc button control led
    2022-01-26 04:50:58下载
    积分:1
  • 总线是一种高效的建模结构。使用它们产生选择…
    Buses are a powerful and efficient modeling construct. Using them to produce optimal code is dependent on following a basic set of best practices. This document provides a set of patterns that can be followed the best results
    2022-09-15 00:40:04下载
    积分:1
  • 696524资源总数
  • 103939会员总数
  • 12今日下载