喷泉阀 ControllerIt 将控件喷泉阀按 SIG 引脚级。它是用于生成不同水质的影响

嵌入式的一个ARM可一直的程序，是学习嵌如式LINUX的很好的学习资料，希望需要的朋友下来-embedded ARM may have been one of the procedures, Learning is embedded Linux as a good learning information and the need to see a friend down

这是一个串口通信的一个软件，本产品是应用在监控器上的软件．-This is one of a serial communication software, the product is applied to the monitoring device on the software.

u盘电路详细资料--Detailed circuit materials for U disk.

tms320c54x dsp单片机资料,与大家共享一下-tms320c54x dsp microcontroller information, and share what

这个程序可以帮助 msp430 先发投手，能够使所述微控制器与系统使用 uart 通信。

I2C总线的实例程序，用PROTEUS+KEIL演示-Examples of I2C bus procedures, PROTEUS+ KEIL presentation with

ARM2410 要更多的远吗，联系我哦。 都是可运行的，-ARM2410 to do far more, contact me, oh. Are operational,

开发环境为uClinux2.4.x+s3c44b0。此程序以字节方式对IIC器件进行读写。通过硬件测试，可以直接使用。附：IIC测试程序。具体使用说明见其中的readme.txt。-development environment for uClinux2.4.x s3c44b0. This procedure in byte pairs IIC device reading and writing. Through hardware testing can be used directly. Report : IIC test. Specific use see the readme.txt.

总的来说，在uClinux上的开发和标准Linux还是很类似的。通常可以按照下面的步骤去设计和调试： 建立基于以太网的开发环境； 如果所设计的程序和硬件的关联不大，那么一定要在标准Linux上先编译和调试通过。灵活地使用gcc和gdb将大大节省时间； 将x86上的GCC编译好的应用程序用交叉编译工具来编译；如果编译时发现错误，那么很可能存在以下问题： 交叉编译器或库文件的路径不正确；最彻底的解决办法是重新装一次编译器； 遇到库不支持的函数；此时需要自己把函数的实现做成另外一个库供应用程序使用。如果是uClinux本身不支持的调用，那么就需要改写代码了。-Overall, the uClinux on the development and standard Linux is still very similar. Usually can use the following steps to design and debug : Ethernet-based development environment; If the design of the procedure and not linked to the hardware, then it must be the first standard Linux compiler and debugging through. Flexibility in the use of gdb and gcc will greatly save time; X86 will be on the GCC-compiled application with cross-compiler tool to compile; If you compile time error is found, it was very likely that the following issues : cross-compilers or libraries are not the correct path; The most radical solution is a re-installed time compiler; encountered does not support functions; At this time the need to