-
用单片机16F877A外接MAX518实现正弦波输出
用单片机16F877A外接MAX518实现正弦波输出-16F877A MCU external realize sinusoidal output MAX518
- 2022-07-14 21:19:06下载
- 积分:1
-
飞思卡尔车身控制技术研讨会资料 里面有LIN的主从节点源程序...
飞思卡尔车身控制技术研讨会资料 里面有LIN的主从节点源程序-Freescale Seminars Body Control has inside information on the LIN master-slave node source
- 2022-05-09 14:46:57下载
- 积分:1
-
本文档是翻译后的ATMEL的8bit单片机atmega16l的中文数据手册,供参考...
本文档是翻译后的ATMEL的8bit单片机atmega16l的中文数据手册,供参考-this document is the chinese spec of atmega16l
- 2022-03-20 10:58:21下载
- 积分:1
-
采用51系列单片机硬件电路对TEA5767收音模块控制源码
采用51系列单片机硬件电路对TEA5767收音模块控制源码-51 Series single-chip hardware circuit of TEA5767 radio module control source
- 2022-01-21 04:09:25下载
- 积分:1
-
使用Viaccess 3银卡PIC18F2620
Use Viaccess 3 on Silver card with PIC18F2620
- 2022-01-26 06:25:03下载
- 积分:1
-
此文件为AT45DB ATMEL芯片的驱动程序实例,串行闪存编程…
本文件为atmel公司的at45db芯片的驱动程序实例,对于串行flash编程有帮助-this document for the at45db ATMEL chips Driver example, serial flash programming for help
- 2022-05-31 02:12:44下载
- 积分:1
-
高精度实时时钟-SD2001驱动程序 用于威帆电子SD200X系列IC驱动...
高精度实时时钟-SD2001驱动程序 用于威帆电子SD200X系列IC驱动-high-precision real-time clock-driven procedures for SD2001 Granville sails electronic SD200X Series Driver IC
- 2022-05-15 19:33:59下载
- 积分:1
-
基于IAR embedde workbench的MSP430原理的心电检测源码。实现手持心电检测...
基于IAR embedde workbench的MSP430原理的心电检测源码。实现手持心电检测-IAR embedde workbench based on the principle of the MSP430 ECG detection source. Realize handheld ECG detection
- 2022-01-22 01:02:26下载
- 积分:1
-
6段数码管分别显示,时,分,秒,四个按键,K1(P0.0),K2(P0.1),
K3(P0.2),K4(P0.3),四个按键用来调时间的,按下K1,所有位都...
6段数码管分别显示,时,分,秒,四个按键,K1(P0.0),K2(P0.1),
K3(P0.2),K4(P0.3),四个按键用来调时间的,按下K1,所有位都清零显示,然后按下K2,秒在闪烁,继续按K2分闪烁,不段地按K2 秒--分--时切换着闪烁,在某位闪时按下K3相应位加一,确认调整,按K4,取消调整再按K1。在K1按下以后才有调时的功能,如果K1没有按下,按别的键没有反映。这为了在加点按键功能留着用
-6 respectively of the digital control, when, minutes and seconds, four keys, K1 (P0.0). K2 (P0.1), K3 (P0.2), K4 (width), the four keys to the transfer time, press the K1, All spaces are reset, then press K2, the scintillation seconds, according to K2 pm flickered. not according to K2 of seconds-- minutes-- when switching to flicker in certain press the flash-K3 corresponding increase in a confirmed adjustment by K4, then canceled K1 adjustment. K1 in the press will only be made after the transfer of function, if K1 pressed by other key is not reflected. This points to the function keys used Retention
- 2022-08-13 14:18:02下载
- 积分:1
-
用c51编写写的x25045的读写程序,
用c51编写写的x25045的读写程序,-used to prepare written procedures x25045 reader,
- 2022-09-04 02:45:03下载
- 积分:1