-
12位da转换程序，调试通过
12位da转换程序，调试通过-12 da conversion process, debugging through
- 2023-09-06 11:20:02下载
- 积分：1
-
单片机做的电子密码锁，proteus仿真通过，学习的好资料
单片机做的电子密码锁，proteus仿真通过，学习的好资料-Single-chip electronic locks do, proteus simulation adoption, learn good information ...
- 2023-06-17 08:35:03下载
- 积分：1
-
SCM SCM curriculum design, curriculum design class curriculum design class Class...
单片机课程设计类 单片机课程设计类-SCM SCM curriculum design, curriculum design class curriculum design class Class SCM
- 2022-07-22 04:29:48下载
- 积分：1
-
采用ADC0809采集数据，并通过串口上传到上位机，采用C语言编写，简单易懂...
采用ADC0809采集数据，并通过串口上传到上位机，采用C语言编写，简单易懂-using data acquisition, and through serial upload it to the PC using C language. easily understood
- 2022-07-28 05:38:32下载
- 积分：1
-
关于16行64列的LED点阵，能够左右移动，程序简单易懂，希望大家来下载...
关于16行64列的LED点阵，能够左右移动，程序简单易懂，希望大家来下载-16, line 64 on the LED dot-matrix, can move around, the program easy-to-read, I hope everyone to download
- 2023-03-02 13:25:03下载
- 积分：1
-
单片机C语言音乐程序的源程序（KeilC代码）
单片机C语言音乐程序的源程序（KeilC代码）- Monolithic integrated circuit C language music procedure source
program (KeilC code)
- 2022-07-18 20:39:37下载
- 积分：1
-
程序能够实现将十二位的二进制数5V对应fffH变换成一路0~5V的电压。
精度方面：在使用时上下波动范围大约是0~2fH能保证高位寄存器准确；
调试过程...
程序能够实现将十二位的二进制数5V对应fffH变换成一路0~5V的电压。
精度方面：在使用时上下波动范围大约是0~2fH能保证高位寄存器准确；
调试过程中遇到了一系列问题：（1）p0口的使用需接上拉电阻，内部没有带电阻；（2）调试的过程最好使用单步运行，以便于察看寄存器的内容；（3）对系统板不熟悉，一些硬件方面容易出问题，像口连接，电源、地的连接。（4）直流电源使用不准确，内部的各个电源输出是独立的，需要共地。
-procedures to achieve 12 to a binary number 5V counterparts fffH transform all the way into the 0- 5V voltage. Accuracy : the use of fluctuating ranges of 0 ~ 2fH can guarantee accurate high register; debugging process encountered a series of questions : (1) p0 I need to connect to the widening use of resistance, with no internal resistance; (2) the process of commissioning the best use of single-step operation, in order to inspect the contents of Register; (3) The right not familiar with the system board, Some hardware problems are likely to occur, such as connectors, power, and connectivity. (4) DC power supply use of inaccurate, all within the Power output is independent, to the total needs.
- 2023-03-22 15:25:03下载
- 积分：1
-
DIY示波器的全部资料，目前很多人都在搞这样的DIY,上传这些资料希望能帮到这些人！...
DIY示波器的全部资料，目前很多人都在搞这样的DIY,上传这些资料希望能帮到这些人！-Oscilloscope DIY all the information that many people are currently engaged in this kind of DIY, From the information I hope to help these people!
- 2022-01-24 16:58:10下载
- 积分：1
-
IC Card operating software : AT88SCl604 chip mode of operation there are five. T...
IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作： AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位： 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位： 当CLK为低时，在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位，而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta
- 2022-05-28 08:23:00下载
- 积分：1
-
We design fire alarm, and basically meet the requirements of everyone can refer...
我们设计的火灾报警器，基本上满足要求，大家可以参考-We design fire alarm, and basically meet the requirements of everyone can refer to
- 2022-08-25 16:11:42下载
- 积分：1
