-
123456
根据所给样本数据用三种不同的方法绘制该公路并估计其长度。
分别用线性插值法、最近邻域插值法和三次样条插值法计算公路长度，并用勾股定理估计公路的长度
(According to the sample data in three different ways, the road map and estimate its length. , Respectively, by linear interpolation, nearest neighbor interpolation domain and cubic spline interpolation method to calculate the length of highways and roads with an estimated length of Pythagorean Theorem)
- 2008-12-10 22:13:46下载
- 积分：1
-
MATLAB_ann_tools
matlab环境下ann的一些用法和示例(some usage, and examples of ann under matlab environment )
- 2014-08-24 15:35:17下载
- 积分：1
-
Model-matematyczny-statku-Cybership-II
polish book about cybership 2
- 2013-10-28 05:17:33下载
- 积分：1
-
Adams_Onelegged
ADAMS与Matlab 联合仿真单足机器人跳跃(union simulation of one-leg hopping robot by ADAMS and MATLAB)
- 2020-11-19 15:19:37下载
- 积分：1
-
TSP_tabu
This project includes solving of TSP with Tabu Search Algorithm. It has been codded for final term project
- 2014-01-10 07:41:56下载
- 积分：1
-
196
A hardware-in-the-loop simulation of a wind
energy conversion system is used to assess a MPPT strategy
for different velocities. The actual system is composed of the
blade, a mechanical power train, a squirrel cage induction
generator and power electronics. The experimental set-up
consists of a DC drive connected to the induction generator.
The DC machine is controlled to impose the same behavior as
the wind turbine to the induction generator. Fluctuations of
wind velocity and non-linear characteristics of the turbine are
taken into account. All numerous model and controls blocks
are organized according to Energetic Macroscopic
Representation for real-time implementation. A very simple
MPPT strategy without wind velocity measurement is
achieved using a look-up table. This strategy includes a
rotation speed limitation. Experimental results are provided
for weak and medium wind profiles.
- 2014-02-14 05:48:48下载
- 积分：1
-
2
说明： this file is about risk managment in marketing....
- 2013-05-25 13:50:47下载
- 积分：1
-
bernoulli
This MATLAB code from MATLAB central file
- 2009-12-08 00:18:34下载
- 积分：1
-
maxcost
“基于Floyd最短路算法的Ford和Fulkerson迭加算法”的最小费用最大流算法，其基本思路为：把各条弧上单位流量的费用看成某种长度，用Floyd求最短路的方法确定一条自V1至Vn的最短路；再将这条最短路作为可扩充路，用求解最大流问题的方法将其上的流量增至最大可能值；而这条最短路上的流量增加后，其上各条弧的单位流量的费用要重新确定，如此多次迭代，最终得到最小费用最大流。
(" Floyd shortest path algorithm based on the Ford and Fulkerson algorithm superposition" of the minimum cost maximum flow algorithm, the basic idea is: the flow of each arc on the unit cost as a length, with Floyd for the most short-circuit method to determine a from V1 to Vn of the most short-circuit then this can be expanded as the shortest way, by solving the maximum flow of traffic on the way to its maximum possible value and this increased the flow of the shortest path, on which the arcs of the unit to re-determine the cost of traffic, so several iterations, finally get the minimum cost maximum flow.)
- 2010-12-22 17:27:32下载
- 积分：1
-
REST_V1.6_110505
进行静息态fMRI数据处理软北师大开发的件包REST(REST toolbox for resting state fMRI analysis)
- 2011-10-29 01:32:17下载
- 积分：1
