-
matlab_program_4
Matlab实用程序
85-100是：数值分析篇(Matlab Utilities)
- 2009-02-12 16:15:57下载
- 积分：1
-
Causal-IIR
Non-Causal IIR Filter
Part 1: Setting up the Input signal to the Wiener Filter
Part 2: Seperating the negative lags and positive lags... The one at 0 index is
clustered together in the positive part highqq
- 2013-07-27 21:57:34下载
- 积分：1
-
06637146
Abstract— In the area of image processing, several methods of
edge detection have been proposed till now like Sobel, Robert,
Prewitt, Canny, Marr-Hildreth etc. All these methods are having
their own advantages and disadvantages. In this paper a new
method has been proposed for edge detection using Cellular
Automata. Different rules have been applied for edge detection.
The outputs are better in terms of clarity and computation time.
Finally, the edge detection has been applied for detecting
cancerous cells in brain. Using Cellular Automata rules helps in
determining the exact location and size of tumor as edges
detected using Cellular Automata are fine, continuous and clear.
The results
- 2014-09-12 17:46:12下载
- 积分：1
-
TP-matlab
Question 1
Question 2
Question 3
3-a) Gaussian filtering with different values ecrats types of noise
Gaussian
3-b) Gaussian filtering with different values ecrats types of noise
pulse
Question 4
4 - a) Median filtering with different window sizes of a noise
Gaussian
4-b) median filtering with different window sizes of a noise
pulse
Question5
5-a) sigma filter applied to a Gaussian noise
5-b) sigma filter applied to an impulse noise
6 - Conclusion
- 2011-04-28 21:19:28下载
- 积分：1
-
潮流计算程序1
说明： 潮流计算是电力学名词，指在给定电力系统网络拓扑、元件参数和发电、负荷参量条件下，计算有功功率、无功功率及电压在电力网中的分布。潮流计算是根据给定的电网结构、参数和发电机、负荷等元件的运行条件，确定电力系统各部分稳态运行状态参数的计算。通常给定的运行条件有系统中各电源和负荷点的功率、枢纽点电压、平衡点的电压和相位角。待求的运行状态参量包括电网各母线节点的电压幅值和相角，以及各支路的功率分布、网络的功率损耗等。(Power flow calculation is a term of power science. It refers to the calculation of the distribution of active power, reactive power and voltage in power network under given network topology, component parameters and generation and load parameters. Power flow calculation is based on the given grid structure, parameters and operation conditions of generator, load and other components to determine the steady-state operation parameters of each part of the power system. Usually, the given operating conditions include the power of each power source and load point, junction voltage, balance point voltage and phase angle. The parameters to be determined include the voltage amplitude and phase angle of each bus node, the power distribution of each branch and the power loss of the network.)
- 2020-06-23 10:00:01下载
- 积分：1
-
天线波束方向图
说明： 考虑一长度为D，宽度为L的理想均匀面阵天线，并用Matlab画出其二维波束方向图。(Consider an ideal uniform planar array antenna with length D and width L, and draw its two-dimensional beam pattern with MATLAB.)
- 2020-09-30 16:07:42下载
- 积分：1
-
LSM_bandcut50
自适应均衡器的仿真程序：在120hz信号下去处50hz干扰(adaptive equalizer Simulation : 120hz signal on the Department 50hz interference)
- 2007-06-26 23:05:08下载
- 积分：1
-
fft-dft
说明： fft算法，fft与dft算法的比较，并有详细的文档说明。(fft algorithm, fft compared with the dft algorithm and a detailed description of the document.)
- 2009-08-07 18:14:56下载
- 积分：1
-
DemoGUI
采用matlab进行GUI设计的一个实例(GUI design using matlab to an instance of)
- 2011-05-15 10:20:38下载
- 积分：1
-
three-level-DTC
基于三电平空间电压质量控制的异步电动机直接转矩控制(Based on a three-level quality control of space voltage induction motor direct torque control)
- 2013-12-15 15:11:22下载
- 积分：1
