-
PSK_modulation
PSK调制的原始matlab代码,可以直接使用,打打基础(matlab code for PSK modulation )
- 2010-02-02 11:20:56下载
- 积分:1
-
pvsystem
光伏发电系统,可用于新能源发电系统的研究设计 (PV systems)
- 2020-11-26 16:09:32下载
- 积分:1
-
source
输入信号为方波信号+高斯白噪声,方波信号基 频为1kHz,幅值为1,高斯白噪声方差为0.2, 均值为0,采样频率为20kHz。试用最大熵估计 法估计此信号的AR模型及其功率谱,并分析结 果(The input signal is a square wave signal+ Gaussian white noise, square wave signal fundamental frequency 1kHz, amplitude is a Gaussian white noise variance is 0.2, the mean is 0, the sampling frequency is 20kHz. Try maximum entropy estimation method to estimate the AR model of this signal and its power spectrum, and analyze the results)
- 2013-10-29 17:50:45下载
- 积分:1
-
chazhiyunihe
MATLAB软件的差值与拟合的思想简介和MATLAB的实现,适合初学者参考(MATLAB software and fitting the difference between the ideological profile and MATLAB implementation of reference for beginners)
- 2010-09-25 19:21:20下载
- 积分:1
-
RobustAdaptiveControl1
robus adaptive control system simulator in Matlap Simulink
- 2010-11-19 11:57:41下载
- 积分:1
-
water-level
关于汽包水位的控制系统的simulink调试代码。(about water level control )
- 2015-04-07 17:13:32下载
- 积分:1
-
parameter-estimation-
Welch法谱估计和参数模型谱估计的MATLAB分析(Welch spectral estimation MATLAB analysis and parameter estimation of the model spectrum)
- 2013-12-25 18:50:31下载
- 积分:1
-
通信原理仿真信号部分
说明: 窄带高斯噪声复包络、同相正交分量的自相关函数及功率谱密度(Autocorrelation function and power spectral density of complex envelope and in-phase orthogonal components of narrow-band Gaussian noise)
- 2019-11-09 18:29:38下载
- 积分:1
-
DFIM
一个用S函数写成的在dq坐标系中的双馈异步电机模型。(An S function written using dq coordinate system in the doubly-fed induction motor model.)
- 2009-04-15 21:12:37下载
- 积分:1
-
eee
杨氏双缝干涉
两相干光源到接收屏上P点距离r1=(D2+(y-a/2)2)1/2, r2=(D2+(y+a/2)2)1/2,
满足相干条件的光波叠加后,对于观察屏上某一确定点,即r1、r2确定后,叠加后的光强为 式中λ为光波的波长, 、 ,令相位差φ=2π(r2-r1)/λ,
最后可得公式如下:
,
最后光强I=4I0cos2(Φ/2)。
观察相干光叠加后光强的分布.
(Young' s double slit interference two coherent light source to the point P on the receiving screen distance r1 = (D2+ (YA/2) 2) 1/2, r2 = (D2+ (y+a/2) 2) 1/2, meet coherent conditions lightwave after superposition, for a determined point on the viewing screen, i.e. R1, R2 is determined, the superimposed light intensity where λ is the wavelength of light, make the phase difference φ = 2π (R2-R1)/λ, final can be obtained using the following formula: Finally, the light intensity I = 4I0cos2 (φ/2). Observed coherent superposition of light intensity distribution.)
- 2013-01-03 21:04:13下载
- 积分:1