-
interp
实现拉朗日插值、线性插值、样条插值，用MATLAB计算两种二维插值的方法。(Implementation date lalang interpolation, linear interpolation, spline interpolation, calculated using MATLAB in two methods of two-dimensional interpolation.)
- 2009-04-04 09:12:03下载
- 积分：1
-
Avgfilt
The program illustrates average or mean filter implementation in matlab.
- 2011-05-21 05:10:53下载
- 积分：1
-
Gauss
使用高斯消元法解非奇异线性方程组，数值分析(Gaussian elimination method for solving non-singular linear equations, numerical analysis)
- 2013-03-23 16:04:12下载
- 积分：1
-
Seminario-Matlab
matlab par velocidad motores cd shunt serie compuesto
- 2014-01-08 04:02:22下载
- 积分：1
-
ICEE-574
The model used for creating the reference voltage is shown
in Fig. 4. First, photovoltaic output current (Ipv) and output
voltage (Vpv) are passed through a first order low pass filter
with a magnitude of G = 1 and a time constant of T = 0.01
seconds in order to filter out the high frequency components
or harmonics from these signals as shown in Fig. 5 and Fig. 6.
The filtered current and voltage signals (Ipv_F and Vpv_F) are
then fed into the MPPT control block that uses the Incremental
Conductance Tracking Algorithm. An algorithm that is based
on the fact the slope of the PV array power curve shown in
Fig. 7 is zero at the Maximum Power Point (MPP), positive on
the left of the MPP, and negative on the right. The MPP can
thus be tracked by comparing the instantaneous conductance
(I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
- 2013-07-23 17:54:09下载
- 积分：1
-
VSI-Fed-IM-Drive
This is the matlab simulation of VSI fed Induction Motor Simulation.
- 2011-12-16 04:05:52下载
- 积分：1
-
elcshuiping
说明： 产生水平地震波的小程序，希望对作地震分析的同仁有用处！(level of seismic waves generated by small program, and I hope to make seismic analysis of the usefulness of us!)
- 2006-04-13 09:35:46下载
- 积分：1
-
zhengchangxinyin
基于matlab心音信号处理，正常异常心音的波形图绘制(Matlab signal processing based on heart sounds, abnormal heart sounds normal waveform drawing)
- 2011-06-05 19:33:42下载
- 积分：1
-
3busconejo
interruptible load program
- 2013-07-12 18:36:29下载
- 积分：1
-
FMINCON
C=CURVEFIT( 拟合模型 ,参数C初值,X数据,Y数据) 求参数C使得 sum {(FUN(C,X数据)-Y数据).^2}最小化(C = CURVEFIT ( fitting model and parameter C, initial X, Y data) for data parameters that sum {there (C) (C, X-ray data- Y j ^ 2) minimizing})
- 2010-08-16 20:23:31下载
- 积分：1
