-
rake-receiver
MATLAB仿真WCDMA下行链路RAKE(MATLAB simulation of WCDMA downlink RAKE)
- 2007-11-14 17:19:04下载
- 积分：1
-
fftplot
自己编写的fft变换的MATLAB源代码！里面还有操作过程。很好用哦(Have written MATLAB s fft transform the source code! There is also the process. Oh, well used)
- 2009-12-14 15:22:40下载
- 积分：1
-
FDTD_1
由于Matlab软件的网络通信局限,使得在并行时域有限差分( FDTD)计算仿真中,难以实现子域间的消息发送与接收操作(As the Matlab software, network communications limited, so in parallel finite difference time domain (FDTD) simulation calculation, it is difficult to achieve sub-domain of the message and receive operation)
- 2010-05-18 20:12:16下载
- 积分：1
-
Matlab_zuixiaoerchengfa
最小费用最大流算法通用Matlab函数
基于Floyd最短路算法的Ford和Fulkerson迭加算法 基本思路：把各条弧上单位流量的费用看成某种长度,用Floyd求最短路的方法确定一条 自V1至Vn的最短路 再将这条最短路作为可扩充路,用求解最大流问题的方法将其上的流 量增至最大可能值 而这条最短路上的流量增加后,其上各条弧的单位流量的费用要重新 确定,如此多次迭代,最终得到最小费用最大流.( Minimum cost maximum flow algorithm for general Matlab functions based on the Floyd shortest path algorithm of Ford and Fulkerson superposition algorithm of the basic ideas: the cost of unit flow on the arc as a certain length of Floyd for the most short-circuit method to determine the one percent V1 through Vn are the most short-circuit then this short circuit as a scalable road, a method for solving the maximum flow problem on flow increased to the maximum possible value that the shortest way increased traffic, the cost of unit flow on each arc sure, so many iterations, the final minimum cost maximum flow.)
- 2012-07-27 14:54:17下载
- 积分：1
-
SVMPCA
在机器学习中经常会用到支持向量机，该代码是再使用支持向量机前对数据进行主成分分析的代码(We often meet support vector machine in machine learning , the code is about the principal component analysis befor using support vector machine (SVM).)
- 2011-12-02 16:54:02下载
- 积分：1
-
data
Elman神经网络的数据预测—电力负荷预测模型研究(neural network data test,research of electric power)
- 2019-04-01 10:20:32下载
- 积分：1
-
Modelling_systems_linear_objects_some_systems
STEP:
1.Bringing descriptive model matemaryczny dyiiamike obiektii issue.
2.Present the resulting model in the form of transmittance merging appropriate input and output size.
3. Move the resulting model as rownaii state.
4. By making use of differential equations that describe rowname dyiiamike obiektii modeled. build a model in srodowiskn MATLAB / Simulink.
5.Przy carry out a model built using the experiments indicated by conducting classes and graphs to present position and speed of the system elements.
6. Discuss the correctness of obtained in the course s> wyiiikow stimulations.
- 2010-12-05 00:51:41下载
- 积分：1
-
stft-111
利用matlab 进行段数傅里叶变换，进行频谱分析，对于从事相关工作的人很有帮助。(The number of segments by using Fourier transform of MATLAB, frequency spectrum analysis, is helpful to be engaged in relevant work.)
- 2013-11-26 15:53:13下载
- 积分：1
-
Kmeans
k-means聚类算法在MATLAB的实现(k-means clustering algorithm in MATLAB implementation of)
- 2009-12-23 18:49:30下载
- 积分：1
-
example
基于LMS的自适应信道均衡，训练序列采用QPSK信号，从星座图可直观的观察结果(LMS-based adaptive channel equalization, the training sequence using QPSK signal constellation can be observed from the observation)
- 2021-04-27 17:08:44下载
- 积分：1
