-
AdaptiveThreshold.tar
Adaptive Threshold method matlab realisation
- 2009-06-10 21:37:17下载
- 积分：1
-
DC-MOTO-PROCESS-SIMULINK
直流电动机瞬态运行过程仿真过程和分析 理论 波形 电路(Process simulation and analysis of transient operation of the DC motor theory waveform circuit)
- 2013-04-23 01:59:04下载
- 积分：1
-
trackHu
轨迹跟踪---船舶航迹控制，典型的欠驱动控制问题。两种算法，采用了matlab---simulink，直观明了。(Sailing ship trajectory tracking control, a typical under-actuated control. Two algorithms using matlab--- simulink, intuitive and clear.)
- 2020-06-29 08:00:02下载
- 积分：1
-
FIR_LP
说明： 用matlab实现FIR低通滤波器的设计(Using matlab to achieve the design of FIR low-pass filter)
- 2010-04-02 10:29:45下载
- 积分：1
-
MATLAB_mse
本文采用最小平方误差准则(MSE准则)通过训练样本集建立线性判别函数，并用线性判别函数去判断测试集。
数据集报告：
1、男女生
2、sona
3、ups(In this paper, the least square error criterion (MSE criterion) the training sample set by a linear discriminant function, and a linear discriminant function to determine the test set. Data Set Report: 1, boys and girls 2, sona 3, ups)
- 2010-05-13 21:38:08下载
- 积分：1
-
fengwo
matlab画的峰窝图(Matlab painting peak Waterloo map )
- 2007-06-03 03:57:53下载
- 积分：1
-
p-sv-wave-nmo
读取水平单层介质单炮记录进行p-sv转换波动校正，并输出动校正之后的结果(Reading level single medium shot record the results of p-sv conversion fluctuation correction and output after NMO)
- 2014-05-29 10:22:30下载
- 积分：1
-
Copy_3_of_Untitled
The WSN clustering based upon fuzzy logic has been discussed, which elaborates the step wise clustering on the different distances. One directional clustering has been represented. The fuzzy clustering has been represented the right to left connection establishment. The energy consumption has been monitored over the given simulation.
- 2016-04-17 13:48:27下载
- 积分：1
-
mixGMMmatlab
混合高斯建模方法是目标检测中的一种重要方法( mix gauss detection object )
- 2010-05-20 18:55:23下载
- 积分：1
-
chap4
被控对象为G(S)=400/（s*s+500s）,首先运行模糊控制器程序chap4_2.m,并将模糊推理系统保存在a2中，然后运行模糊控制SIMULIK程序。位置指令为0.5sin（10t）,simulink见chap4_3(Controlled object is G (S) = 400/(s* s+500s), first run the fuzzy controller program chap4_2.m, and stored in a2 fuzzy inference system, and then run the fuzzy control SIMULIK program. Position command is 0.5sin (10t), simulink see chap4_3)
- 2013-07-22 21:28:56下载
- 积分：1
