-
Simulatedannealingapplication
cost存放了一个强连通图的边权矩阵，作为一个实例。
可在workspace中加载
运用此算法要注意多次试验。(storage cost of a strongly connected graph the right side of the matrix, as an example. Can be loaded in the workspace to use this algorithm to the attention of many tests.)
- 2009-05-14 16:40:00下载
- 积分：1
-
noiseeeeeee
自适应噪声对消器，适用于采样信号的白噪声消除。(Adaptive noise cancellation, and applied to sample the signal to eliminate the white noise.)
- 2009-05-14 01:12:22下载
- 积分：1
-
GRE
GRE的学习资料，很全的大全~~~想出国的同学注意了~(GRE study materials, it is the whole of the Daquan ~ ~ ~ want to go abroad students attention ~)
- 2010-01-06 19:38:20下载
- 积分：1
-
exp5
水平场地和倾斜场地挖填土方量计算MATLAB示例代码(Horizontal cut and fill venues and venues tilt earthwork calculations MATLAB sample code)
- 2013-12-21 16:15:49下载
- 积分：1
-
MoM_standing_wave
使用矩量法计传输线上的驻波，并将结果显示出来．(The use of moment method of transmission lines of the standing wave, and the results are displayed.)
- 2007-08-21 02:43:41下载
- 积分：1
-
case_study_2
enjoy with studying but not with this
- 2012-04-16 19:07:40下载
- 积分：1
-
Laplace
Laplace金字塔算法的图像处理Matlab程序Laplace(Laplace in Matlab)
- 2013-11-03 20:28:42下载
- 积分：1
-
problem1
awlr a awti po tieat iaueotiuuaeigt
- 2012-10-29 05:25:18下载
- 积分：1
-
Wind
a new circuit topology of a
phase-locked loop that can be used for synchronising a singlephase
wind turbine generator (WTG) with the low voltage utility
grid. The circuit is based on the time-delay digital tanlock loop
(TDTL) architecture and was modelled and simulated using
Simulink/MATLAB. The results presented demonstrate the
ability of the circuit not only to synchronise a WTG with the grid,
but also to re-gain synchronization following a sudden
disturbance in the grid voltage. The simulated disturbances
included a ramp and a multi-step change in the phase of the grid
voltage waveform.
- 2013-12-16 13:19:43下载
- 积分：1
-
postme---Copy
The code introduces postcoding technique in ofdm system that results in a much less complex mechanism and provide similar result as are obtained with precoded system. In this technique the coding part is done after the ifft block that is initially the data is converted to frequency domain n then coding is introduced.
- 2011-04-20 20:25:59下载
- 积分：1
