登录
首页 » Visual C++ » main

main

于 2020-07-01 发布 文件大小:3KB
0 212
下载积分: 1 下载次数: 8

代码说明:

  本项目是基于Cortex-M3 的地沟油快速检测装置,旨在实现“地沟油”快速,现场检测。MCU控制可编程的直接数字频率合成器(DDS)产生正弦激励信号,经过可变增益放大器(VGA)和低通滤波器(LPF)作用于食用油阻抗传感器(实验室制作)信号经过仪器放大器送入微控制器(MCU)的模数转化(ADC)通道,MCU对采集的信号通过快速傅里叶变换(DFT)处理,实现食用油阻抗与相角的检测;USB和以太网接口,可与计算机通讯,以便对采集的数据进行存储和分析。(The project is based on the Cortex-M3 waste oil rapid detection device designed to achieve " waste oil" rapid, on-site testing. MCU control programmable direct digital frequency synthesizer (DDS) generates sinusoidal excitation signal through a variable gain amplifier (VGA) and a low-pass filter (LPF) acting on the oil-impedance sensor (lab produced) to send signals through the instrumentation amplifier into the microcontroller (MCU) modulo conversion (ADC) channels, MCU signal acquisition via Fast Fourier Transform (DFT) processing, oil resistance and phase angle detection USB and Ethernet interfaces, and computer communication, in order to collect data for storage and analysis.)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • Beginning-Visual-C_-2012-Programming
    Beginning Visual C_ 2012 Programming
    2014-10-25 22:47:42下载
    积分:1
  • CT
    说明:  双路输出控制器”具有信号输出时间设定、 输出信号占空比调整、 当前输出通道及时 间显示、系统工作参数存储、串口通讯及 LED 指示等功能。 “双路输出控制器”通过串口完 成信号输出时间设定功能;通过 EEPROM 完成系统工作参数存储功能;通过按键完成输出通 道切换、 输出信号占空比调整及停止信号输出功能; 系统硬件电路主要由 MCU 控制单元、独 立按键、 LCD 显示单元、 串口通讯单元、 EEPROM 数据存储单元和 LED 指示单元组成(Dual output controller has the signal output time setting, adjust the duty cycle of the output signal, the current output channel in time Between display, system operating parameters are stored, serial communications and LED indicator. Dual Output Controller through serial END A signal output time setting function complete system operating parameters via EEPROM memory function complete output pass through the key Channel switching, adjust the duty cycle of the output signal and the stop signal output function the system hardware circuit is mainly controlled by the MCU unit, alone Li buttons, LCD display unit, serial communication unit, EEPROM data storage unit and LED indication units)
    2015-03-10 20:14:34下载
    积分:1
  • STM32_LCD1602
    学习使用contex-m3的stm32f103c6的程序库,LCD1602驱动程序。(Learn to use contex-m3 of stm32f103c6 the library, LCD1602 driver.)
    2011-07-14 10:09:26下载
    积分:1
  • RTOS
    说明:  各位C51的爱好者能够看到我的拙作,这离不开龙 啸九天版主的支持,在此,我向他表示感谢,也相信C51BBS会越办越好!(C51 fan you can see my apology, which is inseparable from Long Xiao nine moderator support in this, I thanked him, and believe C51BBS will be better and better!)
    2011-04-11 09:44:53下载
    积分:1
  • led
    51单片机的led灯亮的c语言 程序使其旋转形成圆形(five one single chip microcomputer)
    2011-12-26 09:45:59下载
    积分:1
  • shumaguanPhongwai
    红外遥控发送指令,解码模块接收后,送给数码管显示(Infrared remote control sending instruction, decoding module receives, sends the digital tube display)
    2012-12-19 15:40:24下载
    积分:1
  • LIN6-i0P9999-int
    PIC18F2420 用中断方式从0加到9999 采用四位工阳极数码管(PIC18F2420 interrupt from 0 added to the 9999 four workers anode digital tube)
    2012-09-05 15:24:02下载
    积分:1
  • anjian
    此程序为4*4矩阵键盘,键盘自身不带电源电阻,八个接线,在程序中进行需进行软件拉高拉低以便按键扫描。 应用单片机为MSP430F5529。(4* 4 matrix keyboard without power resistors MSP430F5529)
    2014-07-04 16:25:28下载
    积分:1
  • sd
    说明:  通过读出SD卡中320x240像素、16位BMP图片的HEX数据,依次写到屏上,还原图片(Read SD card in 320x240 pixels, 16 BMP picture HEX data, in turn written to the screen to restore the picture)
    2012-05-25 23:19:07下载
    积分:1
  • digital-thermometer
    利用数字温度传感器DS18B20与单片机结合来测量温度控制器,使用单片机AT89C51,测温传感器使用DS18B20,用3位共阳极LED数码管以串口传送数据,实现温度显示。(Binding to measure the temperature controller, using the AT89C51 microcontroller, DS18B20 temperature sensors, with a common anode three LED digital serial transmission of data to achieve using a digital temperature display and temperature sensor DS18B20 microcontroller.)
    2020-06-26 15:40:02下载
    积分:1
  • 696518资源总数
  • 105877会员总数
  • 14今日下载