-
pv_modele2
PHOTOVOLTAIC MODELISATION WITH SIMULINK
- 2013-11-06 20:55:50下载
- 积分:1
-
antenna-lobe-pattern-simulation
本程序对天线中的一种重要类型:
半波、全波、三倍半波天线波瓣图
进行了仿真和三维成像。有助于对天线中波瓣图的理解。(This procedure of an important type of antenna: half wave, full-wave, three times the half-wave antenna lobe pattern simulation and three-dimensional imaging. Contribute to the understanding of the antenna lobe pattern wave.)
- 2013-11-22 21:18:02下载
- 积分:1
-
qam
16 qam simulation using mathlab to carry out
- 2010-06-28 15:16:46下载
- 积分:1
-
kalmanb
关于gps的kalman滤波程序段,很有用的,呵呵(Kalman filter on the gps program segment, very useful, huh, huh)
- 2009-05-20 16:36:13下载
- 积分:1
-
ask-modulate
说明: 通信原理系统仿真系列--ASK的调制。供刚接触到matlab编程的朋友使用。(communications system simulation series-- ASK modulation. For Matlab programming begin to use a friend.)
- 2006-04-17 10:03:48下载
- 积分:1
-
雷达信号处理基本流程
去斜处理(宽带的匹配滤波)Stretch方法是针对线性调频信号而提出的, 其方法是将输入信号与参考信号 (经适当延迟的本振信号, 延迟量通常由窄带信号测距结果估计出) 混频 ,则每一个散射点就对应一个混频后的单频分量,对混频输出的信号进行 DFT 处理 ,即可获得目标的距离像,对参考信号的要求是应具有与输入信号相同的调频斜率。(dechirp matched filter
Stretch method is proposed for linear frequency modulation signal. It mixes the input signal with the reference signal (local oscillator signal with appropriate delay, the delay is usually estimated from the result of narrowband signal ranging). Then each scattering point corresponds to a single frequency component after mixing, and DFT is performed on the mixed-frequency output signal. The range profile of the target can be obtained by processing, and the reference signal is required to have the same frequency modulation slope as the input signal.)
- 2018-10-31 20:07:27下载
- 积分:1
-
1111
说明: 基于Matlab的扩频高度表捕获跟踪算法软件仿真(Matlab-based spread-spectrum acquisition and tracking algorithm for software simulation altimeter)
- 2010-03-29 10:52:30下载
- 积分:1
-
WienerScalart96
维纳滤波语音增强算法:语音增强算法的维纳滤波器,通过scalart 1996提出的实现。使用一个决策指导的方法跟踪的先验信噪比。请注意,该信号的第一0.25sec用于模型的噪声,即,它是假定的演讲之后,0.25sec开始(Wiener Filter for Noisy Speech Enhancement, implemented as proposed by Scalart 1996. Uses a decision directed method to track the a priori SNR. Note that the first 0.25sec of the signal is used to model the noise, that is, it is assumed that speech starts after that 0.25sec)
- 2013-10-21 20:49:51下载
- 积分:1
-
Attachments_20131017
DIFFERENT ARTICLES , USEFUL FOR ELECTRICAL ENGINEERING , ECONOMIC DISPATCH
- 2013-12-22 16:18:13下载
- 积分:1
-
Artifact-reduction-using-fuzzy-filtering
Artifact reduction using fuzzy logic
- 2014-02-04 14:57:27下载
- 积分:1